Laserfiche WebLink
Chevron Monitoring Certifica—on Checklist <br /> Store Number: 307709 Address: 10858 TRINITY PKWY STOCKTON,CA 95219 <br /> Date:3/24/2017 Technician: Steve Willems Company:TANKNOLOGY INC. <br /> Step Instruction T1 T-2 T-3 <br /> Product UNLEADED PREMIUM Diesel <br /> Tank Type <br /> (DW FRP,DWSteel,SWFRP) Fiberglass Fiberglass Fiberglass <br /> 1 Annular Riser Height(measured) <br /> Tank Diameter:(from tank chart, <br /> 2 118.00 in. 118.00 in. 119.50 in. <br /> for example:118.375",117.75",111",92",etc.) <br /> 3 For FRP tanks,1/2 circumference of the tank 185.26 in. 185.26 in. 187.62 in. <br /> (o.s x 3.14 x tank diam.)OR(q.s 7 x step 2) <br /> Required annular sensor length: <br /> 4 FRP=Riser+112 Circumference=step 1+step 3 185.26 in. 185.26 in. 187.62 in. <br /> Steel=Riser+diameter=step I+step 2 <br /> Mark&label the required sensor length on <br /> 5 sensor cord.Label should be under the cap& <br /> serve to prevent the cord being pulled too short. <br /> Is tank annular sensor in the correct position? <br /> 6 FRPTanks:with the marked required length <br /> lining up with the top of the annular riser? <br /> Steel Tanks:sensor touching bottom with slack <br /> above the marked required sensor length? <br /> Are the DW pipe boots pulled back in tank sumps? <br /> 8 (YIN or N/A,note if can't be verified because N/A N/A N/A <br /> clamshell pointing down) <br /> Are tank sump sensors back in their holders and <br /> 9 in the correct position? N/A N/A N/A <br /> (YIN or N/A document with photo) <br /> 7 Approximate gallons of product dispensed for <br /> purging,etc.and returned to tank <br /> Has the Veeder Root Battery been replaced&dated prior to failsafe? Replaced Today <br /> (If battery backup failed,label and leave failed battery on top of console,note in comments and advise your OM) <br /> Has Veeder Root Programming before&after testing been printed&verified? <br /> (especially tank monifolding setup-see Note 2) Yes <br /> Has Veeder Root Programming before&after been attached to the Work Order? Yes <br /> Have all sensor model numbers been verified against the Veeder Root cord label? <br /> Make a note sensor label missing or illegible,&approx.cord length for-208/-209 with missing labels Yes <br /> if <br /> Additional Comments: <br /> annulars are brine filled <br /> Note 1: Certain Veeder Root Software versions will automatically revert to the default tank manifold settings anytime the programming is changed,such as when sensors are <br /> temporarily X'ed out,etc. <br />