COMPLIANCE INFO_2006 - 2008 - Laserfiche WebLink

Home Browse Search

Monitoring System Certification Site Address: 10858 TRINITY PKWY Date of Testing/Service: 12/28/2007 F. In -Tank Gauging / SIR Equipment ❑ Check this box if tank gauging is used only for inventory control. ❑ Check this box if no tank gauging or SIR equipment is installed. This section must be completed if in -tank gauging equipment is used to perform leak detection monitoring. Complete the following checklist: ❑ Yes ❑No ' Has all input wiring been inspected for proper entry and termination, including testing for ground faults? ❑ Yes ❑No Were all tank gauging probes visually inspected for damage and residue buildup? ❑ Yes ❑ No ' Was accuracy of system product level readings tested? ❑Yes ❑No' Was accuracy of system water level readings tested? 171 Yes ❑No ` Were all probes reinstalled properly? ❑ Yes ❑ No ` Were all items on the equipment manufacturers' maintenance checklist completed? * In the Section H, below, describe how and when these deficiencies were or will be corrected. G. Line Leak Detectors (LLD) : ❑ Check this box if LLDs are not installed. Complete the following checklist: ❑ Yes ❑ No ❑N/A For equipment start-up or annual equipment certification, was a leak simulated to verify LLD performance? (Check all that apply) Simulated leak rate: ❑ 3 g.p.h ❑ 0.1 g.p.h ❑0.2 g.p.h Yes ❑ No ' Were all LLDs confirmed operational and accurate within regulatory requirements? Yes ❑No' Was the testing apparatus properly calibrated? ❑ Yes ❑ No ` ❑ N/A For mechanical LLDs, does the LLD restrict product Flow if it detects a leak? ❑ Yes ❑No ` ❑ N/A For electronic LLDs, does the turbine automatically shut off if the LLD detects a leak? ❑ Yes ❑No ' ❑ N/A For electronic LLDs, does the turbine automatically shut off if any portion of the monitoring system is disabled or disconnected? ❑ Yes ❑No ' ❑ N/A For electronic LLDs, does the turbine automatically shut off if any portion of the monitoring system malfunctions or fails a test? ❑ Yes ❑No ` ❑ N/A For electronic LLDs, have all accessible wiring connections been visually inspected? ❑ Yes DN. ` Were all items on the equipment manufacturers' maintenance checklist completed? * In the Section H, below, describe how and when these deficiencies were or will be corrected. H. Comments: Replaced and tested S7 smart sensor. ONLY Tested O.K. Page 3 of 3 Based on CA form dated 03/01