COMPLIANCE INFO 1994-2010 - Laserfiche WebLink

Home Browse Search

0 Software Version Installed: N/A Comolete the following checklist: 0 ® Yes ❑ No* Is the audible alarm operational? ® Yes ❑ No* Is the visual alarm operational? ❑ Yes ❑ No* Is the print function operational? ® Not installed. ® Yes ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? ® Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) ® N/A operational? ❑ Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment ® N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment Sensors. Did you confirm positive shut -down due to leaks and sensor failure/disconnection? ❑ Yes; ❑ No. ❑ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no ® N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank till pint(s) and operating ro rl ? If so, at what percent of tank capacity does the alarm trigger? ❑ Yes* ®No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E, below. ❑ Yes* ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ Product; ❑ Water. if yes, describe causes in Section E, below- ® Yes ❑ No* Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable ® Yes ❑ No* Is all monitoring equipment oerational per manufacturer's specifications? * In Section E below, describe how and when these deficiencies were or will be corrected. E. Comments: This system consists of a single three -compartment tank monitored by an Incon 1000 panel without a printer. Inventory readings are provided by a set of in -tank "Safety Gauges" which consist of a tapemeasure with a float on one end and a weight on the other. The piping is a 'Jack Koffelt Straight -Up' system that provides full double wall suction piping vertically from the tank to under the dispenser. The tank is directly under the island.