Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: 119.05 <br />Complete the following checklist: <br />OCT 2 6 2015 <br />!o Yes <br />r No* <br />Is the audible alarm operational? <br />(, Yes <br />r No* <br />Is the visual alarm operational? <br />f* Yes <br />r No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />• Yes <br />r No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with <br />heir proper operation? <br />o Yes <br />f No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) operational? <br />r N/A <br />r Yes <br />r No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring <br />i <br />stem detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors Initiate positive shut -down? (Check <br />N/A <br />all that appy sump/Trench Sensors, r Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection?$ Yes; r No <br />Yes <br />C No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no mechanical overfill <br />C <br />prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If <br />N/A <br />o at what percent of tank capacity does the alarm trigger? 90% <br />Yes' <br />f: No <br />as any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the <br />manufacturer name and model for all replacement parts in Section E below. <br />C Yes* <br />r No <br />as liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br />Product r Water. If yes, describe causes in Section E below. <br />G Yes <br />r No* <br />as monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />i « Yes <br />f No* <br />s all monitoring equipment operational per manufacturer's specifications? <br />. in section t beiow, aescnbe now ana when these aeticiencies were or win be corrected. <br />site has an t3 sensor that is not found, states its an oilsump, unable to find or test sensor. <br />Monitoring System Certification Page 2 of 3 12/07 <br />