Laserfiche WebLink
Veeder-Root Sensor Application Guide <br />Sump Sensor <br />The Piping Sump Sensor is installed in a tank piping sump and will detect the presence of a liquid. Liquid level is <br />monitored by a float /magnetic reed switch sensing system. <br />Sensor Detection Capabilities - Alarm Conditions <br />• Fuel alarm is triggered when liquid reaches a nominal height of 1 -inch. <br />• An open sensor triggers a Sensor Out alarm. <br />Operating Capabilities <br />• Operating temperature range: 0 to +60°C. <br />• Storage temperature range: -40 to +70°C. <br />• Sensor dimensions: 12" high, 1.9" diameter. <br />Sensor/Cable Length Configurations <br />• Sump Sensor w/ 12 foot cable - Form Number 794380-2081 <br />• Sump Sensor w/ 30 foot cable - Form Number 794380-2091 <br />'Sensors 794380-208 and -209 are direct replacements for sump sensor 794380-205. <br />Sensor Interface Module <br />• TLS -350 series consoles (except TLS -350J) - Interstitial/Liquid Sensor interface module (P/N 329358-001) <br />accepts up to 8 sensors (a maximum of 64 sensors could be monitored by the console). <br />• TLS -350J console - 3 sensors max. <br />• TLS-300/PC-300 series consoles (no interface module required) - 8 sensors max. <br />• ILS -350 console - A Two -Wire Module (P/N 329675-001) accepts up to 4 sensors (a maximum of 16 sensors <br />could be monitored by the console). <br />• TLS -450 - USM (P/N 332812-001), accepts up to 16 sensors <br />Console Software Compatibility <br />• TLS -350 series/TLS-300 (Version 1 or later) <br />• ILS -350 (All) <br />• TLS -450 (All) <br />Compatible Fuels <br />• Unleaded gasoline <br />• Unleaded with up to 5% methanol, <br />15% ethanol, or 15% MTBE <br />• Leaded gasoline <br />• Diesel <br />• Kerosene <br />• Jet fuel <br />• Aviation gasoline <br />Related Sales Literature <br />Visit our website at www.veeder.com <br />for more information on Veeder-Root <br />products and services. <br />Cable to junction box <br />and seal -off <br />'Sump sensor should: <br />1. Rest on the base of the sump. <br />2. Be positioned as close to outer <br />wall as possible. <br />3. Be mounted in a true vertical <br />position. <br />4. Be installed only in a dry sump. <br />`-Existing conduit <br />or piping <br />!p Product <br />Cable to junction <br />pipe <br />. box and seal -off <br />O <br />Sump sensor' <br />(installation examples) <br />Sump base <br />