Laserfiche WebLink
ORG-01C GLOSS ARI OF DATA QL ALIFIERS _.ND-ABBRQ IATIO-44S <br /> Organic Data Oualiflers <br /> A TIC is a suspected aldol-condensation product <br /> B Compound was found to the associated blank and the sample <br />' C Pesticide identification was confirmed by GClMS <br /> D Concentration values reported at a secondary dilution factor, or surrogate or matrix spike recoveries <br /> were not obtained because the extract was diluted for analysts <br /> E Concentration exceeds the instrument calibration range and was subsequently diluted <br /> I Appears on the "results spreadsheet" and "quant reports" to indicate an interference, or it appears on <br /> pesticide Form 8 to indicate an Instrument blank without a surrogate <br /> J Result is an estimated value below the reporting limit,or a Tenatively Identified Compound (TIC) <br /> N Indicates presumptive evidence of a Tentatively Identified Compound (TIC) <br /> P The percent difference between the results from two GC columns is greater than 25%, and the lower <br />' of the two values is reported <br /> T Compound was found in the associated TCLP extraction blank and the sample <br /> U Compound was analyzed for but not detected at or above the reporting limit <br />' X Laboratory-defined qualifier description included in the narrative <br /> " QC result was outside the laboratory control Iimits <br />' Abbreviations <br /> BS Blank Spike spike analysis was conducted on reagent grade water or a matrix free from the analyte(s) <br /> of interest <br />' BSD Blank Spike Duplicate <br /> BRL Below Reporting Limit <br /> CD Calculation Factor used by the Laboratory's Information Management System (LIMS) <br /> DF Dilution Factor <br /> DL Appears m the sample ID to indicate a secondary dilution <br /> LCS or (LC) denotes Laboratory Control Standard <br />' MB Method Blank or (PB) preparation blank <br /> MS Matrix Spike <br /> MSD Matrix Spike Duplicate <br />' NA Not Applicable <br /> NC Not Calculated <br /> NR Not Required <br />' NS Not Spiked <br /> RE Appears in the sample ID to indicate a Re-analysis <br /> REP Replicate analysis <br /> REPREP Sample was reprepared and then reanalyzed <br /> RFW# Equivalent to the laboratory sample identification (LAB ID) <br /> RPD Relative Percent Difference of duplicate analyses <br /> RRF Relative Response Factor <br /> RT Retention Time <br /> RTW Retention Time Window <br />' NOTES <br /> • One or a combination of these data qualifiers and abbreviations may appear in the analytical report <br /> • <br /> Soil sediment and sludge results are reported on a dry weight bans except when analyzed for landfill disposal or incineration <br /> parameters All other results on a solid tnatnx are reported on an "as received"basis unless noted differently <br /> • Reporting limits are adjusted for preparation sample size sample dilutions, and sample moisture content if analyzed on a dry <br /> weight basis <br /> Revised 07/01!44 <br />