COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

44 42 53 -Water Treatme . Oil-Water Separators Introduction to ElectroNge 5 of 42 Electrocoagulation Technology ~' OilTrap Environmental,a leading manufacturer of injected into the process;oxygen and hydrogen are - electrocoagulation(EC)wastewater treatment disassociated from the water causing the coagulated systems, manufacture's a new generation of contaminants to become buoyant. As contaminants electrocoagulation wastewater treatment systems rise to the surface,they are skimmed off,leaving a designed for treating wash-water and wastewater. clear phase of water for reuse or discharged to sewer. The OilTrap ElectroPulse water treatment system can process up to 300 gallons per minute(larger if The EC treatment process has proven successful in needed)of wash-water or wastewater and is removing a variety of contaminants that are typically of a quality that can be recycled or impossible or too expensive to be removed by discharged to a sanitary sewer.Average treatment filtration or chemical treatment systems.Among cost is between$0.003-$0.005 per gallon,or in these contaminants are emulsified oil,TPH(Total other words$3.00-$5.00 per 1,000 gallons. Petroleum Hydrocarbon),suspended solids and heavy metals. System operations and sludge ElectroPulse system uses electrocoagulation,an management is fully automated through the use of electricity-based technology for treating wash-water on-board automation.A PLC(programmable logic and wastewater economically and on-site.As controller) manages all system processes,monitors contaminated water passes through the ElectroPulse operation and errors,and provides direct cells,(3)three treatment reactions occur,which are communication to the factory. The communication integral with the OilTrap ElectroPulse EC system: kit allows OilTrap technicians to monitor the system, adjust operations and processes,and troubleshoot 1)Coagulation-As contaminated water passes the system in real-time from the factory. This through the ElectroPulse cell assembly,DC power is valuable feature of the ElectroPulse system can applied to the cell. Metallic ions slough off from the dramatically reduce cost and time associated with surface of the cell assembly causing the charge of Oil maintenance and problem-solving.Also,there are no &grease and suspended solids to be neutralized. filters to clean or replace. The charge neutralization causes contaminants to coagulate or to mass together becoming large for The ElectroPulse systems are customized and easy removal. The ElectroPulse system does not modular for accommodating floor space.Systems require the use of chemicals expect for pH adjust(if arebeing used in many applications,including heavy required). equipment washing,marinas,military wash operations,forest products processing, aircraft 2)Oxidation-As wash-water or wastewater refurbishing,auto auctions,equipment washing,and contaminated with heavy metals pass through the metal finishing and deburring. ElectroPulse cell,metals are reduced to an oxide. Metal oxides are changed from a dissolved state to a OilTrap Environmental,which has been suspended state and are precipitated from the manufacturing electrocoagulation water treatment water. Heavy metals that are oxidized by passing systems since 1993, providing not only highly through the ElectroPulse cell assembly generally effective technology but a total solution approach pass a TCLP test,which provides significant savings through system design to meet your specific needs for the cost of sludge disposal. and requirements. OilTrap Environmental Inc. 3)Aeration-A natural byproduct of the ElectroPulse 2775 29th Ave.SW EC process is aeration. No air or any other gases are Tumwater,WA 98512 1.800.943.6495 www.oiltrap.com