Laserfiche WebLink
s <br /> IV <br /> r.xcq ane�snrx�e <br /> DATA QUALIFIERS <br />' B - indicates the compound was found in the blank and the sample <br /> E - Concentrations exceed calibration range of the instrument. <br /> I - Indicates Interference <br /> 7 - Indicates an estimated value for either a TIC or an analyte that meets the identification criteria but <br />' the result is less than the specified reporting limit <br /> T - Indicates the compound was found in the TCLP extraction blank and the sample <br />' u - Indicates an inorganic compound was analyzed for but not detected. <br /> U - Indicates an organic compound was analyzed for but not detected. <br /> BS - Indicates matrix analyses were conducted on reagent grade water. <br /> BSD- Blank Spike Duplicate <br /> BDL- Below Detection Limit <br /> D - Indicates that surrogate/matrix spike recoveries were not obtained because the extract had to be diluted <br /> for analysis. <br />' DL - Indicates a secondary dilution <br /> DF - Dilution factor <br />' LCS- Laboratory Control Sample <br />' MB - Method Blank <br /> MS - Matrix Spike <br />' MSD- Matrix Spike Duplicate <br /> NA - Not Applicable <br />' X - Result is by calculation <br />' NS Not Spiked 'Result was outside advisory limits. <br /> NC Not Calculated <br /> NR - Not Required <br /> NOTES <br /> i3-► Sold, sediment and sludge results are reported on a dry weight basis except when analyzed for Landfill disposal <br />' parameters(such as incineration or Illinois Green Sheet parameters) All other mg/kg results are reported on <br /> an "as received" basis Reporting limits are detection limits adjusted for sample size used, dilutions made, and <br /> in the case of dry weight results, the moisture content of the sample <br /> I <br />