Laserfiche WebLink
0 <br /> Yes No Comment <br /> 90 Day Accumulation in Tanks (cont.) <br /> (Section 66262.34) <br /> Is the tank exempt from this article because it ���.2 d � N/�/ <br /> serves only as part of a secondary containment <br /> (�QvI�U ( <br /> system? [66265.190(b) ] — <br /> b <br /> If the answer is yes, for all HW tanks, to either of the two preceding questions, then <br /> skip pages 8 through 16, since they are not applicable. <br /> Are HW or treatment reagents placed in tanks so <br /> they do not cause the tank, ancillary equipment or <br /> the secondary containment system to rupture, <br /> corrode, leak, or otherwise fail? [66265.194(x) ] — <br /> Are controls and practices used to prevent spills <br /> and overflows, including: [66265.194(b)-] <br /> i <br /> (1) Spill prevention controls (e.g. , check ` <br /> valves and dry discount codings)? — <br /> (2) Overfill prevention controls (e.g. , level <br /> sensing devices, high level alarms, automatic <br /> feed cutoff, or bypass to a standby tank)? ]� <br /> (3) Sufficient freeboard in uncovered tanks to <br /> prevent overtopping by wave or wind action or <br /> by precipitation? — — <br /> If a leak or spill has occurred, was 66265.196 �— <br /> complied with (see page 9)? [66265.194(c) <br /> Does transfer or storage of HW in tanks comply / — <br /> with 66265.17(b)? [66265.194(d) ] <br /> Are daily inspections done for the following: <br /> [66265.195(a)-] n P /A <br /> ri <br /> (1) Discharge coni of equipment (e.g. , feed <br /> cutoff, bypass, and drainage systems)? — — <br /> (2) Corrosion or releases of waste in the above <br /> ground portions? — <br /> (3) Data gathered from monitoring and leak <br /> detection equipment (e.g. , pressure and <br /> temperature gauges, monitoring wells)? _ — <br /> (4) Construction materials and area surrounding <br /> tank and secondary containment for erosion or <br /> signs of releases (e.g. , wet spots, dead <br /> vegetation)? — <br /> (4) For uncovered tanks, the level of waste to <br /> comply with 66265.194(b) (3)? — <br /> Are cathodic protection systems inspected six <br /> months after initial installation and then <br /> annually? [66265.195(b) (1) NP — <br /> Revised 7/15/91 Page 8 <br />