COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

r to afe a�rr F rkl' C 1 nd rs f ForkliftCylinder REMOVAL INSTALLING a F®rkli Cylinder Y Equipment(PPE). p Select a full forklift cylinder and inspect the �� Be sure to wear our Personal Protective E ui ment PPE , For this process, cylinder for 4 you should wear rubberized gloves and eye protection. Make sure there is damage or broken or missing parts. Make sure there is « NO SMOKING or other ignition source in the area, NO SMOKING or other ignition source in the area. Make sure the main service valve on the full cylinder is Turn the empty cylinder service valve OFF(clockwise). fully OFF. Check the O-rings in the connectors in the ;r service connection. Disconnect the gas line by unscrewing the service connection Make sure the cylinder has safety labeling. (turning it counterclockwise). Be aware and cautious,as a small amount of gas may be released from the gas line upon disconnection. Using safe lifting practices, place the full cylinder centered in the brackets and in alignment with the key. This will putt e Pressure i Valve a position. mss. P ure Rel'ef Val t the 12 o'clock po 'ti n. When properly situated, secure the cylinder by engaging the brackets. Make sure Release the brackets that hold the cylinder. the straps are tight and secure. Ew Connect the gas line to the service connection and tighten Remove the empty cylinder from the forklift. Be sure to use firmly(clockwise), safe lifting practices. . Turn the main service valve to the full ON position (counterclockwise) and spray the service connection assembly with a soapy water solution to check for any possible leaks. if Store the empty cylinder in the designated safe storage area. you see any bubbfing or smell any gas,turn the valve OFF and Always store with the relief valve at the highest point, even if recheck the connection and O-rings. 00 NOT leave the you believe it to be empty. valve turned 0or oerexte theark ift ifyou cannot ftthe leak° _ . . ,� :: an �!