COMPLIANCE INFO 2008-2015 - Laserfiche WebLink

Home Browse Search

Veeder-Root POS ApplicatiARuide • RECEIVED DIM Descriptions JUN 19 2015 Mechanical Dispenser Interface Module (MDIM) & Low Voltage Dispenser 19MENTAL Module (LVDIM) nFpeR'rAAFNT • The mechanical dispenser interface modules enable the TLS-350R console to monitor either high voltage (MDIM), or low voltage (LVDIM)volume pulses and calculate dispensed volume. • MDIMs have 8-pin and LVDIMs have 10-pin external rectangular connectors. Electronic Dispenser Interface Module (EDIM) • Installs in a communication port of TLS-350R. EDIMs are used to communicate via RS-232 to point of sale or system controllers. • More than one EDIM can be installed in any combination with other DIM types. • EDIMs have one 25-pin D connector outside of the port. • Red and green LEDs are on this board.When red LED is turned On, EDIM is transmitting to external device; when green LED is turned On, external device is transmitting to EDIM. Current Loop Dispenser Interface Module (CDIM) • Installs in a communication port of TLS-350R.Various CDIM monitoring applications include current loop, RS- 232, and RS-422. • More than one CDIM can be installed in combination with other DIM types. • CDIMs have three RJ-45 modular connectors. • CDIMs cannot transmit to external device. • Connects via 4-wire cable to cable adapter box.Adapter box converts target communication format to RS-422 format for CDIM. Adapter boxes are configured with 2-wire flying leads, 25-pin D or 9-Pin D, T-cable connectors for various applications. LAN Dispenser Interface Module (LDIM) • Installs in a communication port of TLS-350R to communicate with or monitor POSs, dispensers or system con- trollers using RS-485 communication standard. • An LDIM can be installed in combination with other DIM types. • LDIMs have a 5-wire phoenix connector. • Red and green LEDs are on this board.When red LED is turned On, LDIM is transmitting to external device; when green LED is turned On, external device is transmitting to LDIM. • Can be used in 4-wire or 2-wire, RS-485 and RS-422 applications. - DIP switch default in OPEN position, loopback jumper on LED side for RUN mode - R1 -331076-001 -RS-485 two wire - R2 -331076-002 - RS-422 four wire - R3-331076-003- DIM RS-485 two wire (install in TLS-350R only) - R4-331076-004-DIM RS-422 four wire (install in TLS-350R only) International Forecourt Standards Forum Dispenser Interface Module (IFSF) • Required for TLS Consoles that are connected to IFSF networks. • Uses Echelon 2-wire FTT10-A medium, as defined by the IFSF standards. • There are 3 LEDs on this board: - Green LED On when IFSF board is transmitting information to the TLS. - Red LED On when TLS is transmitting information to the IFSF board. - Amber LED Off indicates normal state of the IFSF board processor. • There are no LED indicators for network communication. 4 VEEDER-ROOT