Laserfiche WebLink
0 0 <br />Replacing Software/Memory Modules on the BCPU Board Installing the ECPU Board <br />2Removing <br />the board is over ridge in base of <br />modules - <br />3 Use your fingers to spread <br />connector, then push board back <br />retaining clips away from <br />Attach one end of the <br />board's edges. DON'T FORCE BOARD <br />the module board edges, <br />9 <br />antistatic wrist strap to <br />1� 453 <br />kilt in the board to the front <br />your wrist and the tither <br />correctly then try again. <br />of the console and lift it out. <br />end to the bare metal <br />base inside the console. <br />Module retaining clips <br />✓I <br />(one on each end) <br />Rod, �. Turn ac power to console OFF. <br />1 Push SW1 down to turn <br />battery backup OFF. <br />Removing Software and Memory Modules <br />Seat module in connector J1 at <br />an angle with component side facing <br />the front of the console Make <br />sure that notch in the bottom of <br />the board is over ridge in base of <br />connector, then push board back <br />until retaining clips snap around the <br />board's edges. DON'T FORCE BOARD <br />or you may damage socket? Check <br />1� 453 <br />that notch and ridge are aligned <br />correctly then try again. <br />tt` <br />Retaining clip (2) <br />Front of console <br />-4— <br />s , � <br />J1 LJ J2 <br />View A -A (above) <br />ECPIJ boa <br />/I/ <br />Installing Software and Memory Modules <br />637-2.aps <br />Figure B. Removing and Installing a Software or Memory Module <br />5. Perform a cold boot as described in "Performing a Cold Boot" on page 11. <br />14 <br />