COMPLIANCE INFO 2013-2015 - Laserfiche WebLink

Home Browse Search

Introduction This manual contains procedures for the installation or replacement of the Veeder-Root Mag Sump Sensor. This manual assumes all preliminary site preparation is completed, and that field wiring from the console to the pan/ sump junction box is in place. Following Mag Sump Sensor installation,you will need to configure and select certain programmable features of this sensor at the TLS Console. NOTE: If the Mag Sump Sensor you are installing has NQ programmable features (i.e., alarm upgrade delay,water warning height, or water alarm height),you will not be able to enter Mag Sensor Setup. Contractor Certification Requirements Veeder-Root requires the following minimum training certifications for contractors who will install and setup the equipment discussed in this manual: Level 1 Contractors holding valid Level 1 Certification are approved to perform wiring and conduit routing, equipment mounting, probe and sensor installation,tank and line preparation, and line leak defector installation. Level 2/3 Contractors holding valid Level 2 or 3 Certifications are approved to perform installation checkout, startup, programming and operations training,troubleshooting and servicing for all Veeder-Root Tank Monitoring Systems, including Line Leak Detection and associated accessories. Warranty Registrations may only be submitted by selected distributors. Related Manuals 576013-879 TLS-3XX Site Prep and Installation Manual 577013-879 TLS-4XX Site Prep and Installation Manual 576013-623 TLS-3XX System Setup Manual Equipment Needed for Installation 1. Mag Sump Sensor(available in two lengths): / 1-foot measurement range, 22-inch overall length - Part No. 857080-XX1 2-foot measurement range, 34-inch overall length - Part No. 857080-XX2 2. Cable- 10 feet- Part No.330272-002 3. Cable Seal Kit-Part No.330020-067 4. Optional- Universal Sensor Mounting kit- Part No. 330020-012. 1