Laserfiche WebLink
D. Results of Testing/Servicing <br /> Software Version Installed NA <br /> Complete the following checklist: <br /> ® Yes ❑ No' Is the audible alarm operational? <br /> Yes ❑ No' Is the visual alarm operational? <br /> ® Yes ❑ No' Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> ® Yes ❑ No` Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br /> operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station,is all communications equipment(e.g,modem)operational? <br /> ® NIA <br /> �] Yes No' For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak, <br /> ❑ NIA fails to operate, or is electriral4y disconnected? If yes: which sensors initiate positive shut-down? (Check all that apply) ❑ SumplTrench <br /> Sensors; ❑Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failureldisconnection? ❑Yes; ❑No. <br /> ❑ Yes ❑ No- For tank systems that utilize the monitoring system as tthe primary tank overfill warning device(i.e., no mechanics#overfill prevention valve is <br /> ❑ NIA installed),is the overfill warning alarm visible and audible at the tank fill point(s)and operating properly? If so,at what percent of tank capacity <br /> does the alarm trigger? % <br /> ❑ Yes ® No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name <br /> and model for all replacement parts in Section E,below. <br /> ❑Yes' ❑ No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply} <br /> ❑Product; ❑Water. If yes,describe causes in Section E,below. <br /> Yes ❑ No` Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> ❑ Yes ❑ No' Is all monitoring equipment operational per manufacturer's specificaficns? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: LINE TEST DONE <br /> Monitoring System Certification Page 2 of 4 1('1i0 <br />