Laserfiche WebLink
D. Results of"Westin /Servicin <br /> � g <br /> Software Version Installed: f -5 6 Z. <br /> �I <br /> Co fete the following checklist: <br /> Yes ❑ No* Is the audible alarm operational? <br /> es ❑ No* Is the visual alarm operational? <br /> ,❑ 'es ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? <br /> Yes ❑ No* Were a]l sensors installed at lowest point of secondary containment and positioned so that othe <br /> not interfere with their proper operation? r equipment will <br /> Yes ❑ lo* If alarms are relayed to a remote monitoring station, is all communications equipment e, mode <br /> N/A operational? g m) <br /> Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the Pipingseconds <br /> ry❑ N/A monitoring system detects a leak, fails to operat or is electrically disconnected? If yes: which sensorsa� inane <br /> positive shut-down? (Check all that a Z initiate <br /> Did you conE m positive shut-down due y)leaks and sensor failure/disc❑onnection7 Dispenser Cyes;; El No. <br /> nt Sensors. <br /> ❑ Yes ❑ For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> N/A mechanical overfill prevention,valve is installed), is the overfill warning alarm visible and audible at the to <br /> l!points}and operating properly? If so, at what percent of tank capacity does the alarm trigger? /4 <br /> Yes* No Was any monitoring equipment replaced?P If yes, identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> ❑ Z`e5* No Was liquid found inside any secondary containment systems designed as dry s stems? <br /> ❑Product; ❑ Water, If yes, describe causes,in Section E, below, y (Check all that appl}) <br /> Yes C] No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports, if applicable <br /> ❑/'i'es ❑ No* Is all monitoring equipment operational per manufacturer's specifications? <br /> *In Section E below, describe how and when these deficiencies were or will be corrected. <br /> E. Comments. <br /> Page 2 of 3 <br /> e. 03/01 <br />