INSTALL_1995 - Laserfiche WebLink

Home Browse Search

Site Pre tion and Installation Instruction* GiflbarcoEAIC Basonitoring Console 4. Attach the probe cable connector to the mating plug on CAUTION: IF MORE THAN TWO WIRE NUT the top;of the probe. Be sure the connector is attached CONNECTIONS SHARE AN EPDXY SEALANT securely by hand tightening the locking ring. BAG, THE CONNECTIONS WILL RESULT IN INACCURATE PROBE READINGS AND POSSI-.,,_) 6. Place floats at bottom of probe before standing the BLY FALSE ALARM CONDITIONS. probe on end. i.. � NOTE: Using epoxy sealant furnished with each jj- CAUTION: HANDLE PROBES CAR.EFULLY1 probe,seal wire nut connections using the epoxy kit STRIKING OR DROPPING PROBE WILL RESULT provided with each probe. IN LOSS OF CALIBRATION AND COULD CAUSE WARNING: EPDXY SEALANT MAY BE IRRI- PERMANENT DAMAGE. -W TATING TO EYES AND SKIN. MAY CAUSE 6. Carefully lower probe into the riser pipe until the boot SKIN SENSITIZATION IN SUSCEPTIBLE IN- rests on the bottom of the tank. DIVIDUALS.MAYBE ABSORBED THROUGH THE SKIN. EPDXY SEALANT CONTAINS EP- CAUTION:DO NOTALLOW PROBE TO FREEFALL I OXY RESIN AND VINYL CYCLOHEXENE DI- AND/OR SHARPLY IMPACTTHE BOTI'OM OF THE OXIDE.VINYL CYCLOHEKENE DIOXIDE HAS TANK SHOCK TO THE PROBE FOOT WILL RE- +` CAUSED SKIN CANCER 1N ANM AL TESTS. SULT IN SEVERE PROBE DAMAGE. fi PRECAUTIONS:AVOID EYE AND SKIN CON- T. Cut a length of flexible conduit leaving enough Mack TACT. WEAR IMPERVIOUS GLOVES AND to remove the riser cap. SAFETY GLASSES.USE ONLY IN WELL VEN- 8. Remove cable bushing nut. Feed the two-wire probe I TILATED AREAS. cable up through the riser pipe cap bushing and 13. Tighten the cable bushing nuts on the probe riser cap adaptor.(See Figure 26,"Riser Pipe Cap Bushing and and junction box to ensure a water-tight seal at the Adaptor.") probe cable entry. (See Figure 28, "Junction Box 9. Connect the adaptor to the cable bushing but do not Liquidtight Connector."J tighten. 10. Continue to feed the cable through the conduit and conduit connectors. Leave enough slack in the cable between the cap and junction box to allow the cap to - -- easily reach the riser pipe. In addition, leave enou'rh slack under the riser cap to allow the probe to rest on I box the bottom of the tank. `. 11. Using wiring nuts,connect wires from the probe cable to the probe field wires in the junction box i see Figure 27). Be sure to observe proper polarity between theCC 'Ca probe and monitor wiring during installation. The '° E' conduit must be properly sealed in accordance with the National Electrical Code (NFPA 70) and the Automotive and Marine Service Station Code iNFPA 30A) sincethey pass from a Class 1, Division I or Division II area into a non-hazardous area. Figure 29. Junction Box Liquidtight Connector JUNG tERN BOX 14. Secure the riser lockingca to the to of the riser pipe. JUNCTION 0011 cap P P P PER PROBE) a padlock mai• be installed for added security. 2 RIGtO CONOU11 ere • TOTo MomTOR PAOBE Wnt Figure 27. Tyvo-Wire Probe Field Wiring Installation Diagram 12. Seal wire nuts with epoxy sealant using one bag for two wire nut connections.(Refer to Figure 24.-Epoxy Sealant for Two-Wire Connections.") 18 -