Laserfiche WebLink
Tracer Research Corporation <br /> Nonvolumetric TIT Method Tracer Tight (TM) <br /> Version <br /> Test Conditions During Evaluation (continued) <br /> The tests were conducted with the tank varying percent full. <br /> The temperature difference between�pro� duct added to fill the tank and product already in <br /> the tank ranged from N A 'F to N fA °F, with a standard deviation of N/A 'F. <br /> The product used in the evaluation was va , 'ng gasoline, diesel. jet fuel and heating oil. <br /> This method may be affected by other sources of interference. List these interferences <br /> below and give the ranges of conditions under which the evaluation was done. (Check None <br /> if not applicable) <br /> [ ] None - <br /> Interferences Range of Test Conditions <br /> Limitations on the Results <br /> ' The performance has not been substantially changed. <br /> ' The vendor's instructions for using the method are followed. <br /> . The tank contains a product identified on the method description form. <br /> ' The tank capacity is — gallons or smaller. <br /> ' The difference between aded and in-tank product temperatures is no greater than + <br /> or - degrees Fahrenheit. <br /> [ ] Check if applicable: <br /> Temperature is not a factor because Tracer detection outside of tank does not depend <br /> on fuel temperature inside tank Temperature does not affect the amount of Tracer <br /> released. <br /> ' The waiting time between the end of filling the test tank and the start of the test data <br /> collection is at least _ hours. <br /> • The waiting time between the end of "to ping off' to final testing level and the start of <br /> the test data collection is at least <x hours. <br /> ' The total data collection time for the test is at least _ hours. <br /> ' <br /> Thep roduct <br /> volume in the tank during testing is _Q 1 % full. <br /> This method [ ] can [ ] cannot be used if the ground-water level is above the bottom <br /> of the tank. <br /> Other limitations specified by the vendor or determined during testing: <br /> 1 After Tracer chemical is added. you must wait at least 14 days to collectkamoles from <br /> vapor probes 2 Alternative aooroaches must be used if top of tank is under water <br /> These approaches are availab e t rough Tracer Research Corp, <br /> N=mh wdric TIT Md W-Ramdfs Fww FSP 21 3 <br />