Laserfiche WebLink
Tracer Res aarah Corporation <br /> f <br /> Nonvolumetric TIT Method Tracer Tight (TM) <br /> Version <br /> Test Conditions During Evaluation (continued) <br /> The tests were conducted with the tank varying percent full. <br /> The temperature difference between product added to fill the tank and product already in <br /> the tank ranged from N A OF to NA OF, with a standard deviation of N A OF. <br /> The product used in the evaluation was varyinggasoline diesel, iet fuel and heating oil <br /> This method may be affected by other sources of interference. List these interferences <br /> below and give the ranges of conditions under which the evaluation was done. (Check None <br /> if not applicable.) <br /> [ ] None Interferences Range a of Test Conditions <br /> Limitations on the Results <br /> * The performance has not been substantially changed. <br /> * The vendor's instructions for using the method are followed. <br /> * The tank contains a product identified on the method description form. <br /> * 'llie tank capacity is _ gallons or smaller. <br /> * The difference between added and in-tank product temperatures is no greater than + <br /> or - degrees Fahrenheit. <br /> [ ] Check if applicable: <br /> Temperature is not a factor because Tracer detection outside of tank does not depend <br /> oil fuel temperature inside tank Temperature does not affect the amount of Tracgr <br /> released. <br /> * 'Ilie waiting time between the end of filling the test tank and the start of the test data <br /> collection is at least _ hours. <br /> * The waiting time between the end of"topping off' to final testing level and the start of <br /> the test data collection is at least <x hours. <br /> " The total data collection time for the test is at least — hours. <br /> * The product volume in the tank during testing is 0.100 % full. <br /> * This method [ ] can [ ] cannot be used if the ground-water level is above the bottom <br /> of the tank. <br /> Other limitations specified by the vendor or determined during testing: <br /> 1. After Tracer chemical is added you must wait at least 14 days to collect samples from <br /> P IICP <br /> v-ioor probes 2 Alternative ro hes must b d if too of tan is unser water. <br /> These approaches are available through Tracer Research Cora. <br /> Nowrolrehie TIT Medwd-RebaAW Fwm Cage 217 <br />