Laserfiche WebLink
0 '• <br />D. Results of Testing/Servicing <br />Software Version Installed: 331.00 <br />Complete the fiollowinq checklist: <br />® Yes <br />❑ No` <br />Is the audible alarm operational? <br />® Yes <br />❑ No' <br />Is the visual alarm operationai? <br />Yes <br />[] No` <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />Yes <br />No` <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their <br />proper operation <br />Yes <br />El No' <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) operational? <br />® NIA <br />Yes <br />El No` <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring system <br />❑ NIA <br />detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check eft that apply) <br />Z SumplTrench Sensors; ❑ Dispenser Containment Sensors. Did you confirm positive shut -down due to leaks and sensor <br />failure disconnection? Yes' No. <br />❑ Yes <br />❑ No` <br />For tank systems that utilize the monitoring system as the primary tank overfHl warning device (i.e. no mechanical overfill prevention <br />® NIA <br />valve is installed), is the overfill warning alarm visible and audible at the tank fill points) and operating properly? if so, at what percent <br />Flappers <br />of tank ca actty does the alarm trigger? 90% <br />® Yes` <br />❑ No <br />Was any monitoring equipment replaced? if yes, identify specific sensors, probes, or other equipment replaced and list the <br />manufacturer name and model for all replacement parts in Section E, below. <br />Yes` <br />® No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check ad that apply) ❑ Product; ❑ Water. <br />If yes, describe causes in Section E below. <br />Yes <br />No` <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />Yes <br />Ne <br />Is ell monitoring equipment operational per manufacturers specifications? <br />In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments; <br />ECPU board crashed and was unable to recover history or programming. Replaced ECPU board, software and cold started. <br />Reprogrammed Veeder--Root system setup and put back online. <br />Monitoring System Certification Page 2 of 4 12/07 <br />2 2/21107 <br />