COMPLIANCE INFO_2012-2015 - Laserfiche WebLink

Home Browse Search

A 53/A 53M — 06a SUMMARY OF CHANGES Committee A01 has identified the location of selected changes to this specification since the last issue, A 53/A 53M—06, that may impact the use of this specification. (Approved October 1, 2006) (1) Revised LI to address supplementary requirements. (4) Revised 7.3?. (2)Added new 3.1.16 and renumbered subsequent paragraphs. (5) Deleted Note 4 and renumbered subsequent notes. (3) Revised 7.3.1. (6)Added Supplementary Requirement SI. Committee A01 has identified the location of selected changes to this specification since the last issue, A 53/A 53M—05, that may impact the use of this specification. (Approved May 1, 2006) (1) Revised the minimum coupling length for NPS 6 in Table (2)Editorially corrected the minimum coupling length for NPS X3.1. 3/4 in Table X3.1 and the DN designation for NPS 6 in the title for Table X3.1. Committee A01 has identified the location of selected changes to this specification since the last issue, A 53/A 53M—04a, that may impact the use of this specification. (Approved October 1, 2005) (1) Added Practice E 273 to Referenced Documents. (2) Revised 9.1_1 to address NDE methods for ERV✓pipe. ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.Users of this standard are expressly advised that determination of the validity of any such patent lights,and the risk of Infringement of such lights,are entirely their own responsibility. This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years and It not revised.eitherreappmved of withdrawn.your comments are invited either forremion of this standard or for additional standards and should bo addressed to ASTM intemationat Headquarters.your comments will receive careful consideration ata meeting of the responsible technical committee.which you may attend.H you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards.at the address shown below. This standard is copyrighted by ASTM International, 100 Barr Harbor Drive,Po Box C700.West Conshohocken,PA 19428-2959. United Slates. Individual reprints!single or multiple copies)of this standard may be obtained by contacting ASTM at the above address or at 610-832-9585 (phone), 610-832-9555 (tax), or service®as(m.org (e-mail); or through the ASTM website (www.astm.org). 22