COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

WORK PLAN Azonic Technology, Inc. intends to install the Enviro Ranger system at Morton Paint Company with a minimum of distraction to your day-to-day business. ATI's installations in over 200 sites has provided us with experience in working around daily business activities, and in leaving the site in "better than original" condition, and in dealing with regulators. Initially, the work plan will be to dig three to four ground- water wells to determine if there is any contamination. Soil samples at regulator-approved intervals will be taken and analyzed. Once the analysis results are approved, ATI will then install the E.R. system. Vadose probe holes will be sunk into the tanks' backfill (as per attached map) . Trenches will be run to the E.R. device and sample lines installed. The trenches will be resurfaced with concrete and "finished" to match the site environment. A description of our vadose probe and sample line follows; Construction Methodology; Vadose probes: The probe is 3/4" sched. 40 slotted PVC pipe with 0.010" slots at the bottom 48" of probe. Probes are hand driven into the backfill of the fuel or waste tank to the bottom of the fill. Probe is housed in a utility box with a traffic rated cast iron lid. In areas of existing concrete or asphalt, the top of the utility box is set 1/4" higher than surrounding grade to prevent intrusion of rain water or minor accidental spills. The utility box is set in concrete and interior space is grouted and sealed with mortar. Sampling lines: Lines are 3/8" polyethylene tubing from the probe to the controller valve port connection. Where the sample lines rise vertically from the ground to the bottom of the controller sched. 40 PVC conduit is utilized. Should the location of the riser be deemed by the Fire Department to warrant metallic conduit, it will be provided. All horizantal runs above the ground are metallic conduit (EMT) . All trenches are filled with concrete and approximately finished. Effort is made to minimize disturbance of all surfaced areas. All penetrations through vertical walls are weather caulked. Electrical service is hard wired using 12# copper wire and EMT conduit.