COMPLIANCE INFO 1986 - 2016 - Laserfiche WebLink

Home Browse Search

State of Callfomia-Health and Welfare Agenc Department of Health Services J Page 6 of 7 pages RADIOACTIVE MATERIAL LICENSE License Number. 1276-39 Amendment Number. 80 25. Written emergency instructions shall be posted conspicuously at the remote afterloading device control(s). Instructions shall include directions for manually turning off the remote afterloading device(s), removing the patient, securing the room(s) against unauthorized entry, and notifying the responsible authorized user or the Radiation Safety Officer. 26. Electrical interlock(s) on entrance door(s) to the remote afterloading device room(s) shall be tested for proper operation at least once every month or prior to use (if used less frequently). Records of test results shall be maintained available for inspection. 27. If there is a reason to suspect that the source position indicator or entrance door(s) interlock(s) is/are not functioning properly, use of the remote afterloading device(s) shall be discontinued until the condition has been corrected. A record of any such malfunction shall be made and maintained available for inspection. 28. Special Requirements for Remote Afterloading Device Spot Checks and Calibration: (a) At intervals not to exceed daily or prior to use (if used less frequently),the following tests shall be performed: (1) Source position indicator(s). (2) Source positioning reproducibility,to within tlmm. (3) Inspection of guide tubes for kinks and other imperfections. (b) Timing device accuracy shall be performed at intervals not to exceed monthly or prior to each use (if used less frequently). (c) Source travel time error shall be performed at each source loading. (d) At each source loading and then at intervals not to exceed three months, one month for Ir-192, or prior to use (if used less frequently),the licensee shall determine the dose accuracy to within t5 percent. 29. Remote afterloading devices authorized by this license shall not be operated unless the licensee has in his possession detailed written instructions specific for the make and model of the remote afterloading device. 30. Each remote afterloading device shall be inspected and serviced in accordance with the manufacturer's recommendations. 31. For remote afterloading devices, specifically authorized personnel shall: (a) Install,relocate, maintain and repair devices containing radioactive material. (b) Leak test,replace and dispose of sealed sources containing radioactive material used in devices. 32. Subsequent to each source loading,radiation surveys shall be performed prior to human use as follows: (a) A radiation survey shall be made of the unit source housing, with the source(s) in the shielded position. The maximum radiation levels at 20 centimeters from the surface of the source housing shall not exceed 3 milliroentgens per hour. (b) Records of survey results shall be maintained for inspection. 33. Immediately after retracting the source from the patient into its shielded position in the remote afterloading device, a radiation survey shall be made of the patient with a portable radiation detection survey instrument to confirm that the source has been removed from the patient. Records of each survey shall be maintained. 34. Treatment time calculations and data entry for remote afterloaders shall be individually verified by the responsible authorized user physician immediately prior to treatment.