COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

1 N Xn4 0 absorbent material may pose the same hazard as the spilled product.Note: see section 1 for emergency contact information and section 13 for waste disposal. Small spill: Stop leak if without risk.Move containers from spill area. Dilute with water and mop up if water-soluble or absorb with an inert dry material and place in an appropriate waste disposal container. Dispose of via a licensed waste disposal contractor. Section 7. Handling and storage Handling :Put on appropriate personal protective equipment(see section 8). Eating,drinking and smoking should be prohibited in areas where this material is handled,stored and processed.Workers should wash hands and face before eating,drinking and smoking.Persons with a history of skin sensitization problems should not be employed in any process in which this product is used.Do not get in eyes or on skin or clothing.Do not breathe vapor or mist.Do not ingest.Keep in the original container or an approved alternative made from a compatible material,kept tightly closed when not in use.Empty containers retain product residue and can be hazardous.Do not reuse container. Storage: Store in accordance with local regulations. Store in original container protected from direct sunlight in a dry,cool and well-ventilated area,away from incompatible materials(see section 10)and food and drink.Keep container tightly closed and sealed until ready for use.Containers that have been opened must be carefully resealed and kept upright to prevent leakage.Do not store in unlabeled containers. Use appropriate containment to avoid environmental contamination. Section 8. Exposure controls,personal protection Monitoring methods and references: If this product contains ingredients with exposure limits,personal, workplace atmosphere or biological monitoring may be required to determine the effectiveness of the ventilation or other control measures and/or the necessity to use respiratory protective equipment. Engineering measures : No special ventilation requirements.Good general ventilation should be sufficient to control worker exposure to airborne contaminants.If this product contains ingredients with exposure limits,use process enclosures, local exhaust ventilation or other engineering controls to keep worker exposure below any recommended or statutory limits. Hygiene measures : Wash hands, forearms and face thoroughly after handling chemical products,before eating,smoking and using the lavatory and at the end of the working period.Appropriate techniques should be used to remove potentially contaminated clothing. Wash contaminated clothing before reusing. Ensure that eyewash stations and safety showers are close to the workstation location. Hydrous Aluminum Silicate ACGIHTLV-TWA:Threshold Limit Value-Time weighted average PEL:Permissible Exposure 2 mg/m3 Level Respirable fraction OSHAPEL:Permissible Exposure Level total dust j15mg/m3 OSHAPEL:Permissible Ex osure Level Res irable fractio5 mg/m3 NIOSH Time Wei hted Avera (VA total NIOSH Time Weighted Average(TWA)Respirable fraction gj Silica,Amorphous Protective Equipment Respiratory : Use a properly fitted,air-purifying or air-fed respirator complying with an approved standard if a risk assessment indicates this is necessary.Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator. Eyes. : Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes,mists,gases or dusts. Skin :Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Date of issue 3/21/2008 3 of 5 S ec" cation 000000096358