Laserfiche WebLink
Nonvolumetric TTY Method Tracer Tight (TM) <br /> Version <br /> Test Conditions During Evaluation (continued) <br /> The tests were conducted with the tank vaZdng percent full. <br /> The temperature difference between product added to-fill the tank and product already in <br /> the tank ranged from N A °F to &A °F, with a standard deviation of N A °F. <br /> The product used in the evaluation was vai3ing gasoline. diesel, 1 and heating oil <br /> This method may be affected by other sources of interference. List these interferences <br /> below and give the ranges of conditions under which the evaluation was done. (Check None <br /> if not applicable.) <br /> [ ] None <br /> Interferences Range of Test Conditions <br /> Limitations on the Results <br /> * The performance has not been substantially changed. <br /> * The vendor's instructions for using the method are followed. <br /> * The tank contains a product identfied on the method description form- <br /> * The tank capacity is liallons or smaller. <br /> * The difference between added and in-tank product temperatures is no greater than + <br /> or - degrees Fahrenheit. <br /> [ ] Check if applicable: <br /> Temperature is not a factor because Tracer detection outside of tank does not depend <br /> on fuel temperature inside tank Temperature does not affect the amount of Tracer <br /> released. <br /> * The waiting time between the end of filling the test tank and the start of the test data <br /> collection is at least hours. <br /> * The waiting time between the end of "topping off' to final testing level and the start of <br /> the test data collection is at least <x hours. <br /> * The total data collection time for the test is at least hours. <br /> * The product volume in the tank during testing is 0-100 % full. <br /> This method [ ] can [ ] cannot be used if the ground-water level is above the bottom <br /> of the tank. <br /> Other limitations specified by the vendor or determined during testing: <br /> 1. After Tracer chemical is addedyou must wait at least 14 days to collect sam les from <br /> vapor probes. 2 Alternative a roaches must be used if top of tank is under water, <br /> These approaches are available throuEh Tracer Research Co - <br /> Naanai�elric TIT Mei�od-Qecaits Fogs taw 2 of 3 <br /> r <br />