Laserfiche WebLink
TracAeuearch Corporation <br /> Nonvolumetric TIT Method Tracer Tigh"TM <br /> Version <br /> Test Conditions During Evaluation (continued) <br /> The tests were conducted with the tankva in percent full. <br /> The temperature difference between product added to fill the tank and product already in <br /> the tank ranged from NIA OF to "F, with a standard deviation of N/A_ OF. <br /> The product used in the evaluation was var.,Ling, P-as9line diesel...i fuel and heating ail. <br /> This method may be affected by other sources of interference. List these interferences <br /> below and sive the ranges of conditions under which the evaluation was done. (Check None <br /> if not applicable.) <br /> [ ] NoneInterferencesRange of Test Conditions <br /> Limitations on the results <br /> * The performance has not been substantially changed. <br /> * The vendor's instructions for using, the method are followed. <br /> * The tank contains a product identified on the method description form. <br /> * The tank capacity is gallons or smaller. <br /> * The difference between a.rlded and in-tank product temperatures is no greater than + <br /> or - degrees Fahrenheit. <br /> [ ] Check if applicable: <br /> Temperature is not a factor because Tracer e tion Du side of tank does not de end <br /> on fuel tend re ature inside tank. Tgniperitlure dogsnot iffect 1he •moun gf 'Prager <br /> released. <br /> * The waiting time between the end of filling the test tank and the start of the test data <br /> collection is at least hours. <br /> * The waiting time between the end of "topping off' to final testing level and the start of <br /> the test data collection is at least <x hours. <br /> * The total data collection time for the test is at least hours. <br /> * The product volume in the tank during testing is 0-100 % full. <br /> * This method can [ cannot be used if the ground-water level is above the bottom <br /> of the tank. <br /> Other limitations specified by the vendor or determined during testing:. <br /> 1. After Tracer chemical is added. you must wait at least 14 days c 1! c sam !es from <br /> vWj( r probes. 2. Alternative proaches must be use if top of tank is under wz ter <br /> !'hese approaches are available,tiro h Trac r Research or <br /> No.ndh.etrx TIT Metrod-Rcmllb Fors ease 2 of 3 <br />