Laserfiche WebLink
Monitoring System Certification <br /> site Address: 4747 WEST LANE Date of Testing/Service: 03/26/2001 <br /> D. Results of Testing/Servicing <br /> Software Version Installed: <br /> Complete the following checklist: <br /> El Yes Fj No• Is the audible alarm operational? <br /> ❑ Yes ❑No' Is the visual alarm operational? <br /> ® Yes ❑No' Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not <br /> ® Yes ❑No• interfere with their proper operation? <br /> El Yes ❑No' M N/A If alarms are relayed to a remote monitoring station, is all communications equipment(e.g. modem)operational? <br /> For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment <br /> Yes No• ®N/A monitoring system detects a leak,fails to operate, or is electrically disconnected?If yes:which sensors initiate positive <br /> shut-down(check all that apply) i�Sump/Trench Sensors; i�iDispenser Containment Sensors. <br /> Did you confirm positive shut-down due to`7eaks and sensor failure/disconnection?F1 yes No <br /> Yes No* overfill prevention valve is installed),is the overfill warning alarm visible and audible at the tank fill points(s)and operating <br /> INA For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.no mechanical <br /> properly? If so,at what percent of tank capacity does the alarm trigger? % <br /> ❑ Yes ®No• Was any monitoring equipment replaced?If yes,identify specific sensors, probes,or other equipment replaced and list the <br /> manufacturer name and model for all replacement parts in Section E, below. <br /> EJ <br /> Yes ®No as liquid found inside any secondary containment systems designed as dry systems?(check all that applM Product; <br /> Waterlf yes,describe causes in Section E,below. <br /> ® Yes No' Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> ® <br /> Yes No' Is all monitoring equipment operational per manufacturers specifications? <br /> In Section E below,describe how and when these decifiences were or will be corrected. <br /> E. Comments: <br /> page 2 of 3 <br />