Laserfiche WebLink
0 <br /> System. Components <br /> The TC-3000 system consists of three basic 2-Wire Connector Cable—This non- <br /> The <br /> parts. A monitor which continuously reads a degradable cable is used between monitor- <br /> 100K resistor that has been placed at the end of ing wells for 2-wire probes to connect one <br /> the cable. A drop in resistance, a short or break probe to another. it makes connection by <br /> in the cable will signal an alarm. The com- tmeans of a aches to eachpendwater resistant plug at- <br /> ponents which make up the system are des- <br /> cribed as follows: 4-Wire Monitor Cable—This non- <br /> Radial Combo Cable—This wire assembly degradable cable is available in a standard <br /> is used in double wall fiberglass tanks and length of 150' and is used to connect the <br /> Combo Cable in first tank to the TC-3000 <br /> some types of double wall steel tanks. It <br /> consists of bath our petroleum and water Monitor. Only one end of the Monitor Cable <br /> sensing cables inserted into the monitor fit- has a 4-pin plug, the other end is left bare <br /> ting and fished around the interstitial space for wiring into the monitor. <br /> of the tank. 2-Wire Monitor Cable—This non- <br /> 4-wire <br /> Vertical Combo Cable—This `� degradable cable is available in a standard <br /> Ling <br /> ly is used in jacketed steel tanks length of 150' and is used to connect the s <br /> e types of double wall steel tanks. It Petro Cable probe, in the first monitoring <br /> of both petroleum and water sens- well, with the TC-3000 Monitor. <br /> les, which is lowered down into the 4-Pin Terminating Plug—This plug is at- <br /> fitting (standpipe), at the lower endtached to the last length of Combo Cable <br /> ped tank. -m located at the tank which is at the end of the <br /> Petro Cable—This 2-wire sensor cable system. it's purpose is to complete <br /> cable is used in double wall fiberglass tanks the circuit of the entire cable system. (One <br /> and some types of double wall steel tanks. It per system) ; <br /> includes only the petroleum sensing cable 2-Pin Terminating Plug—This plug is st- <br /> and is inserted into the monitor fitting of the tached to the last length of a petro cable <br /> tank and fished around the interstitial space which is located at the monitoring station <br /> of the tank. furthest from the TC-3000 Monitor. it's pur- <br /> r <br /> Vertical Petra Cable—This d id eseannlo$ cable system. (One peis to complete r system) <br /> cable <br /> f the entire f <br /> cable is used in both jacket <br /> and double wall steel tanks as well as TC-3000 Monitor—This mounted monitor is <br /> ground monitoring wells. it monitors only located in the station and is connected to <br /> petroleum infiltration and not water. the system by the Monitor Cable. it has two <br /> Lateral Petro Cable—This 2-wire <br /> alarm circuits; one for signaling petroleum petroleum sensing cable is used for some infiltration and the other to signal water in- <br /> filtration. It is temperature compensated <br /> types of double wall piping as well as pipe and is designed exclusively for use with <br /> trench liners. It monitors only petroleum in- Total Containment sensing cables. A test <br /> filtration and not water. (Custom Sizes Only) switch permits daily inspection of the circuit <br /> 4-Wire Connector Cable—This non- for continuity and proper operation. <br /> degradable cable is used between tanks to `�� <br /> connect one Combo Cable to another. It Adaptor Coupling—This coupling is <br /> makes connection by means of a 4-pin designed to connect a 4-wire cable to a <br /> water resistant plug attached on each end. 2-wire cable. <br /> —2— <br />