COMPLIANCE INFO 1998-2006 - Laserfiche WebLink

Home Browse Search

Monitoring System Certification • Site Address: 2500 W. LODI AVE. Date of Testing/Service: 07/05/2006 LOWER SACRAMENTO RD. F. In-Tank Gauging / SIR Equipment ❑ Check this box if tank gauging is used only for inventory control. ❑ Check this box if no tank gauging or SIR equipment is installed. This section must be completed if in-tank gauging equipment is used to perform leak detection monitoring. Complete the following checklist: ID Yes ❑No• Has all input wiring been inspected for proper entry and termination,including testing for ground faults? ED Yes ❑No• Were all tank gauging probes visually inspected for damage and residue buildup? El Yes ❑No' Was accuracy of system product level readings tested? ❑X Yes ❑No* Was accuracy of system water level readings tested? X Yes ❑No* Were all probes reinstalled properly? Q Yes ❑No* Were all items on the equipment manufacturers'maintenance checklist completed? *In the Section H,below,describe how and when these deficiencies were or will be corrected. G. Line Leak Detectors (LLD) : ❑ Check this box if LLDs are not installed. Complete the following checklist: For equipment start-up or annual equipment certification,was a leak simulated to verify LLD performance. ❑X Yes E]No. ❑N/A (Check all that apply)Simulated leak rate: Q 3 g.p.h❑0.1 g.p.h 00.2 g.p.h X Yes ❑No• Were all LLDs confirmed operational and accurate within regulatory requirements? ❑X Yes ❑No* Was the testing apparatus properly calibrated? ❑X Yes ❑No* ❑N/A For mechanical LLDs,does the LLD restrict product flow if it detects a leak? ❑Yes ❑No• M N/A For electronic LLDs,does the turbine automatically shut off if the LLD detects a leak? ❑Yes ❑No' Q N/A For electronic LLDs,does the turbine automatically shut off if any portion of the monitoring system is disabled or disconnected? ❑Yes ❑No* ❑X N/A For electronic LLDs,does the turbine automatically shut off if any portion of the monitoring system malfunctions or fails a test? E:1 Yes ❑No• Q N/A For electronic LLDs,have all accessible wiring connections been visually inspected? Y ❑No* Were all items on the equipment manufacturers'maintenance checklist completed? *In the Section H,below,describe how and when these deficiencies were or will be corrected. H. Comments: pumped out 5 gals of water from fill sumps 87 and 89 annular sensors have cat5 ethernet wire installed in order to extend them proven functional but incorrect wire,sandy edwards will make sure it is repaired correctly Page 3 of 3 Based on CA form dated 03/01