INSTALL_1992 - Laserfiche WebLink

Home Browse Search

G. Turbine En�res H. Sealed Turbine Enclos� I. Turbine Enclosure (Model TE SPfles) (Model STE Series) Adhesive Kit (Kit-Ad) The turbine enclosure is The sealed turbine When properly installed and constructed of fiberglass enclosure is constructed cured, the adhesive kit pro- reinforced plastic. The tur- of fiberglass reinforced vides a water tight seal to bine enclosure is 42 inches plastic. The sealed turbine prevent the ingress of water. r in diameter and must be enclosure is 42 inch diam- The adhesive kit includes capable of mounting to the eter secondary contain- 1/2 gallon of adhesive in 42 inch diameter secondary ment collar. The minimum a one gallon capacity can. containment collar. Turbine length of the sealed turbine The kit also includes cata- enclosures are a minimum enclosure is two feet and lyst (hardener), a wooden of two feet in length and the maximum is four feet: mixing stick, a three inch are available in one-foot wide plastic putty knife, increments to a maximum sealed Turbine 60 grit sandpaper, and of five feet: Model No. enclosure Length installation instructions. S:E42.2 2 ft. One adhesive kit is Model No. Length STE42-3 a n. required for each turbine TE42-2 2 ft. enclosure; the sealed tur- TE42-3 aft. bine enclosure requires TE42-4 4 ft. The sealed turbine two kits. TE42-5 5 ft. enclosure includes four factory-installed 1 inch Cut lines for field trimming NPT steel electrical fittings J. Turbine Enclosure will be marked on the bottom installed at 90 degree Electrical Fitting Kit 12 inches of the turbine intervals. Kit EF-1 includes four enclosure in three inch 1 inch NPT threaded increments. Cut lines for field trimming couplings, with grommets, are marked on the bottom hole saw with arbor, and The turbine enclosure 12 inches of the sealed tur- installation instructions. top is constructed of high- bine enclosure at three inch Kit GE-3/4 is designed for density polyethylene. The increments. 3/4" OD electrical conduit; top diameter is 42 inches. the kit includes 12 grom- The lid openings are avail- The top and lid of the mets, one hole saw with able in various sizes: sealed turbine enclosure arbor, sandpaper, and are constructed of fiberglass installation instructions. Lid Opening reinforced plastic. The oval Model No. Diameter lid opening (30 inch by 24 PT42-23 20.5 inches inch) includes a 2" NPT Kit GE-1 is designed for 1" PT42-27 24.5 inches threaded fitting (with steel OD electrical conduit; the PT42-32 30.0 inches fitting plug) for access to kit includes 12 grommets, the sealed turbine enclosure one hole saw with arbor, The turbine enclosure top without removing the lid. sandpaper, and installation includes a friction-fit lid The lid also includes the instructions. constructed of high-density following hardware for polyethylene. sealing: If needed, refer to Section 1 1. A rubber gasket. for the optional adhesive 2. Stainless steel threaded kit (to bond the turbine enclosure to the contain- rod and wing nut. ment collar) and Sections J, 3. Carbon steel support K, and L the field installed bar (32" long) fitting kits (for electrical 4. Two lifting handles and plumbing connections constructed of steel. to the turbine enclosure). Cut lines for field trimming will be marked on the bottom six inches of the sealed tur- bine enclosure top in three inch increments. Refer to Section I for optional adhesive kits to bond the sealed turbine enclosure to the FRP top and the secondary contain- ment collar; also refer to Section L for the field installed fitting kit. 31