INSTALL 2018 - Laserfiche WebLink

Home Browse Search

s Figure 3-2 Tank sump Body Extension e - - In freezing conditions,protect collar and tank sump from water accumulation.Freezing water may cause damage. 2.1. Visually inspect the tank sump components for shipping or handling damage.If damage is found,contact Tank Tank Sump Body CSI Field Service. Extension with 2.2. Wear gloves. EnclosureTop Trim to adjust 2.3. Do not roll,drop,abounce. forfinal height 2.4. Tank sump parts and kits should be stored in upright position. 33. Field cuts must be with in-14'of square.Gaps between 2.5. Set on smooth surface. twojoints greater than W must be covered with 2.6. The tank sump must be secured to prevent damage maximum width'A'tape.This prevents resin from from high winds.Proper precautions should be taken to running into joint protect adhesive channels. 3.4. Maintain a minimum of 4'on the tank sump body 2.7. All assembly kits(Klt-AD or KII should be stored in a extension to complete interior joint. cool/drylocatlonatW-70'F.Higher temperatures will 3.5. Even if mating surfaces have arrived from the factory shorten shelf life.Use by expiration date shown on the abraded,the contractor must re-sand the mating box label. surfaces within four hours of adhesive or III s application. e 3.6. Remove any rocks,and/or debris from adhesive channel. 3.7. Sand and clean mating surfaces until white in color. Tank sump mug be Isolated from direct traffic loading. 3.7.1. Adhesive Joints-Sand the surfaces that will contact the adhesive,then wipe free of dust with a clean 3.1. Dry fit all tank sump components prior to installation. cloth. 3.1.1. Determine any length changes required to insure the 3.72. Layup Joints-Sand a minimum of 4'onto each part minimum required clearance between the tank sump where the layup will be applied,then wipe free of top and concrete. dust with a clean cloth. 3.12. Confirm enclosure top and reservoir are level. 3.73. Ensure mating surfaces are free of contaminants and 3.1.3. Verify fill/vapor spill buckets and sensor will properly dry align with lid opening.This is achieved by installing 3,7,4. Do not use oil-based solvents,soap,or water to clean the top section of the tank sump so that the reservoir surfaces. opening is oriented 90'from the tank centedine (see Figure 3-1). 3.8. Insert channel mesh material provided with adhesive kit Figure 3-1 360'around each joint(see Figure 3-3). All/Vapor EnclosureTop Alignment Figure 3-3 U ntAdhesive Channel T.,V r. INSERT CHANNEL MESH 360'IN EACH JOINT e d+ d d a aae mnea rat Allgnmem mmiwct Ponau9nmmt 3.8.1. Mesh is supplied longer than required.Trim end to fit Without gap or overlap. 32. If required,trim tank sump body extension using a carbide tipped blade or a masonry blade.The tank sump body extension is the only component of the tank sump that can be trimmed(see Figure 3-2). 3