Laserfiche WebLink
Vacuum Sensor System Installation Guide Installing Vac Sensor Housing Support Bracket <br /> Barbed tee Piece of tubing (typ.) <br /> Orient the barbed Barbed elbow <br /> tee on this end so <br /> one of the ends <br /> points out <br /> vacsensors?gt6.eps <br /> Figure 5. Attaching vacuum tubing between Vac Sensors <br /> Installing Vac Sensor Housing Support Bracket <br /> Get the Vac Sensor housing support bracket and the curved tensioning clamp from the mounting kit. Hold the <br /> bracket against the STP riser. Place the curved clamp around the back of the riser and hook the four notches in the <br /> clamp over the four barbs in the top of the bracket (see Figure 6). Position the bracket so the top of bracket is at <br /> least 12 inches above the sump floor and hand tighten the tension adjust knob on the back of the clamp until the <br /> assembly is secure. <br /> 6 <br />