Laserfiche WebLink
Installer Menu n#70 Page 7/12 <br /> Install PIN PIN XXXX can be changed <br /> "Error"is displayed if the entered PIN number Input new PIN <br /> has already been allocated to another operator. <br /> Installer <br /> PIN: XXXX <br /> Enter the PIN number and confirm with"OK" <br /> or return with"Quit". <br /> Hose Calibration Calibration or scale factor for each hose(meter). CF= <br /> 100/x-factor. Forexample forllowmeterwith K-factorof251 Select Product: <br /> (Flowmeter K- pulsesigallon,CF=100/251 =0.3984. Enter without decimal Tankl 1 <br /> factor) point as: Tank2 2 <br /> Tank3 3 <br /> CF:03984 Inactive 4 <br /> Select a Tank and confirm with"OK" <br /> or return with"Quit. <br /> ----------------- <br /> Enter the calibration factor and confirm with"OK" CF: 03984 <br /> or return with"Quit. ---------------- <br /> Cal.Constant <br /> 0.000001L/Pule <br /> Ignore the"Cal Constant below the CF. <br /> "THE SAME CF MUST BE ENTERED FOR EACH TANK" <br /> Hose Offset Can correct for over delivery caused by a slowvaNe. The Select Product: <br /> Tank Offset Calibration Offset(CO)is in tenths of gallons. For example,if <br /> ( set) system is delivering 2.91 gallons when calculated amount is Tankl 1 <br /> 2.86 gallons,an offset of 0.05 gallons is entered as: Tank2 2 <br /> Tank3 3 <br /> CO:050000 Inactive 4 <br /> In this example,the system will close the valve when the <br /> dispensed volume reaches 2.82 gallons. The overrun due to <br /> the slowvaNe will result in the correct dispense of 2.87 <br /> gallons. CO: 000000 <br /> ----------------- <br /> Select a Tank and confirm with"OK" Cali.Offset <br /> or return with"Quit. (0.000001L) <br /> Enter the hose offset(CO)and confirm with"OK" <br /> or return with"Quit'. <br /> "THE CO MUST BE ENTERED FOR EACH TANK" <br /> Print Parameter Will print the currentconrtguration on the specified printer No sub menu. <br /> for each Tank. <br /> Setup Printer Printer selection <br /> Printer: 1 <br /> 0:No printer assigned ___ <br /> t:Internal printer non 0 <br /> 2:External printer Internal 1 <br /> 3:internal and external printer <br /> External 2 <br /> Int.& Ext. 3 <br /> LMS_Baby System <br />