Laserfiche WebLink
D. Results of Testing/Servicing • <br /> !1 <br /> Software Version installed: 8.04 <br /> Com late the folio in checklist: <br /> ® Yes ❑ No Is the autlible alarm operational? <br /> ® Yes ❑ No' I-- <br /> 0 <br /> e® Yes ❑ No" Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> ® Yes ❑ No• Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br /> operation? <br /> ❑ Yes ❑ No' If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.,motlem)operational? <br /> ® N/A <br /> ® Yes ❑ No' For pressurized piping systems,does the turbine automatically shut tlown if the piping secontlary ta <br /> ❑ N/A fails to operate, is electrically disconnected? If yes: which sensors initiatconinment monitoring system detects a leak, <br /> e positive shut-down? (Check al/that apply) ® Sumplfrench <br /> Sensors; 181 Dispea nser Containment Sensors. <br /> Did you confine positive shut-down due to leaks and sensor failure/disconnection? ®Yes; ❑No. <br /> ❑ Yes ❑ No` For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e., no mechanical overall prevention valve is <br /> ® N/A installed),is the overfill warning alarm visible and audible at the tank fill point(s)and operating property? If so,at what percent of tank capacity <br /> does the alarm trigger? % <br /> ❑ Yes ® No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and fist the manufacturer name <br /> and model for all replacement parts in Section E,below. <br /> ❑Yes' ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> ❑Product; ❑Water. If yes,describe causes in Section E,below. <br /> ® Yes ❑ No'l Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> ® Yes ❑ No` Is all monitonng equipment operational per manufacturer's specifications? <br /> 'In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Monitoring System ertificatlon Page 2 of 4 2)21/07 <br />