COMPLIANCE INFO 2012-2015 - Laserfiche WebLink

Home Browse Search

Exhibit 3 Droo Tube Overfill Prevention Device Manufacturing Performance Standards and Specifications Each Drop Tube Overfill Prevention Device shall be tested at the factory to,and met,the specification listed in Table 3-1 and shall have affixed to it a card or label listing the performance The Phil-Tice system and all components shall be manufactured in compliance with the specification and a statement that the device was tested to,and met,such performance performance standards and specifications in CP-201,as well as the requirements specified in specification. this Executive Order. All components shall be manufactured as certified;no change to the equipment,parts,design,materials or manufacturing process shall be made unless approved in writing by the Executive Officer. Unless specked in Exhibit 2 or in the ARB approved Table 3-1 Installation,Operation and Maintenance Manual for the Phil-Tile Phase I Vapor Recovery Manufacturing Component Standards and Specifications System,the requirements of this section apply to the manufacturing process and are not .. appropriate to(determining the compliance status of a GDF. Component Test Standard or Specification Method PressureNacuum Vent Valves for Stomae Tank Vent Pines Minimum,360-degree rotation Rotatable Phase I Adaptors TP-201.1B Maximum,108 pound-inch 1. Each PressureNacuum Vent Valve(PN valve)shall be performance tested at the factory ooaverage static rque for cracking pressure and leak rate at each specifed pressure setting and shall be done in accordance with TP-201.1E,Leak Rate and Cracking Pressure of Pressure/Vacuum Rotatable Phase 1 Adaptors Micrometer Cam and Groove Specifications Vent Valves(October 8,2003). (CP-201) Overfill Prevention Device TP-201.1D 50.17 CFH at 2.00 inches H2O 2. Each PN valve shall be shipped with a card or label staling the performance specifications TP-201.1C listed in Table 3-1,and a statement that the valve was tested to,and met,these Spill Container Drain Valve or s0.17 CFH at 2.00 inches H2O specifications. TP-201.1D 3. Each PN valve shall have permanently affixed to it a yellow or gold label with black Positive Pressure:2.5 to 6.0 inches HzO lettering listing the positive and negative pressure settings and leak rate standards listed in PressureNacuum Vent Valve TP-201.1E Negative Pressure:6.0 to 10.0 inches HiO Table 3-1. The lettering of the positive and negative pressure settings and leak rale Leak rate:s 0.05 CFH at+2.0 inches H2O standards on the label shall have a minimum font size of 20. s 0.21 CFH at-4.0 inches H2O Rotatable Product and Vapor Recovery Adaptors 1. The rotatable product and vapor recovery adaptors shall not leak. 2. The product adaptor cam and groove shall be manufactured in accordance with the cam and groove specifications shown in Figure 3A of CP-201. 3. The vapor recovery adaptor cam and groove shall be manufactured in accordance with the cam and groove specifications shown in Figure 3B of CP-201. 4. Each product and vapor recovery adaptor shall be tested at the factory to,and met,the specifications listed in Table 3-1 and shall have affixed to it a card or label listing Nese performance specifications and a statement that the adaptor was tested to,and met such specifications. Spill Container and Drain Valves Each Spill Container Drain Valve shall be tested at the factory to,and mel,the specification listed in Table 3-1 and shall have affixed to it a card or label listing the performance specification and a statement that the valve was tested to,and met such performance specification. Executive Order VR-101-L,FFS Phil-Tice Phase I Vapor Recovery System,Exhibit 3, Page 1 Executive Order VR-101-L.FFS Phil-Tile Phase I Vapor Recovery System,Exhibit 3, Page 2