COMPLIANCE INFO_2017 - Laserfiche WebLink

Home Browse Search

SWRCB,January 2002 Page of 8. FILL RISER CONTAINMENT SUMP TESTING Facility is Not Equipped With Fill Riser Containment Sums ❑ Fill Riser Containment Sumps are Present,but were Not Tested ❑ Test Method Developed By: ❑ Sump Manufacturer ❑Industry Standard X Professional Engineer ❑Other(Spec) Test Method Used: ❑Pressure ❑Vacuum X Hydrostatic ❑Other(SpeciA) Test Equipment Used: Caldwell Level Chan,geIndicator Equipment Resolution: .002 Fill Sump#1-Diesel Fill Sump# Fill Sump# Fill Sump# Sump Diameter: 48" Sump Depth: 65" Height from Tank Top to Top of 26" Highest Piping Penetration: Height from Tank Top to Lowest 30" Electrical Penetration: Condition of sump prior to Dry DEC 1 9 2017 testing: Portion of Sump Tested Water Level 28" Sump Material: Fiberglass AL REAUff- Wait time between applying 5 MinutesT water and startingtest: nEP PTMEN Test Start Time: 1:48 Initial Reading (R,): .001 Test End Time: 2:05 Final Reading(RF): > .030 Test Duration: 15 Minutes Chane in Reading RF-Rt): > .030 Pass/Fail Threshold or Criteria: .005/30 Minutes Test Result: Fail Is there a sensor in the sump? Yes Does the sensor alarm when either product or water is Yes detected? Was sensor removed for testing? Yes Was sensor properly replaced and Yes verified functional after testing? Comments—(include information on repairs made prior to testing, and recommended follow-up forfailed rests) Diesel Fill Riser Sump will not maintain test level and has a gross loss>.030 in 15 Minutes. I reset the Level Change indicator three times to verify a consistent loss. No visual signs of bubbles around Vapor/Vent Piping or Vapor/Vent Piping Penetrations. All Piping and Electrical Penetration in this Sump are Blue Line Material. No visual signs of penetration material degradation at time of this testing. Unable to locate source of loss. Recommend a repair contractor reseal all Piping and Electrical Penetrations in this Fill Riser Sump. Retest after repairs.