Laserfiche WebLink
A) Preparing the Fitting & FRP wall <br /> A.1) Prepare your fittings by identifying the parts. Clean the surfaces of all fittings with <br /> trichloroethylene or acetone to remove any contamination. Hand sand with 60-grit sandpaper if <br /> necessary. Do not lay them on dirt, water, debris or other contaminated surfaces. When dusting off, <br /> use a shop brush, chip brush or compressed air. Do not use rags, cloth or cloth-like material <br /> MIT? <br /> . . DRY-FIT YOUR FITTINGS TO BE SURE THAT THEY ALIGN <br /> i j PROPERLY. <br /> t DO NOT PLAN HOLE SAW CUTS ON UNEVEN SURFACES. <br /> FLAT PANELS ONLY. CAREFUL OF CORNERS AND EDGES. <br /> YOU CAN NOT MOUNT FITTINGS ON ROUND SURFACES <br /> A.2) Dust off Sump walls (inside and out) and drill your pilot holes centered on the planned fitting <br /> locations using a 1/4" Drill bit. Proceed when done to cut your holes with 2-1/2" size hole saw with <br /> 1/4" centralizer. Hand-sand the rough edges inside and outside made by the hole saw. <br /> (DO NOT DRILL CUT OR TAP ANYWHERE ON THE FITTING <br /> DO NOT GLUE/SEAL THE DOUBLE <br /> WALL INTERSTICE AFTER YOUR <br /> HOLE IS CUT... <br /> HOLE SAW SIZE CHART <br /> 2-1 /2 31 for F-17-XX-D, F-10-XX-D <br /> Fig. A3 <br /> A.3) Use the Sanding kit (Page 3, sanding gun sold seperately) <br /> to lightly abrade each hole until the surfaces are flat and even and <br /> white fiberglass is open and visible.(Fig. A3). <br /> Follow the T-FS-SAND-KIT Installation Instructions. <br /> DO NOT OVERGRIND!! MAINTAIN A MINIMUM WALL THICKNESS OF 1/8" INCH. <br /> For other manufacturers, lightly grind off any gel-coat or gloss finish until flat. <br /> Replace any gel-coat or fiberglass that is removed in excess. <br /> Follow Manufacturers Installation Instructions. <br /> 5 ii-F-Series-1 X-SS-D-11 A <br />