INSTALL_2012 - Laserfiche WebLink

Home Browse Search

Sump Entry/Termination Fitting with Bonded Fiberglass Alignment Rings thick to the inside and the out- visible between the rings and it. The use of an industrial hot air side of the sump walls where the the sump wall.The metal ring gun may speed up the curing alignment rings are located.Coat must hold the assembly in posi- process. Do not overheat. cut edges of the entry hole.Apply tion while the adhesive cures.If 12.Remove 1/4"plastic threaded out- a thin coating of adhesive to the the assembly is not tight against let protector.Apply adhesive to bonding surface of the two rings the sump wall,firmly press the the 1/4"fitting and screw into the that will bond to the sump walls. entry fitting against the outside 1/4"threaded outlet.Tighten to S. Line up rings with alignment sump wall while pressing the 40 in.-lbs.or 11/2-2 turns past marks and press together firmly. metal ring against the alignment hand tight. After installing fitting, 9. Slide the metal retaining ring over ring on the inside. be sure the interstitial space is free inside section of sump fitting 10.Do not disturb assembly until the from excess adhesive. Install a against the alignment rings until adhesive is cured.This includes short hose and blow excess adhe- they are tight against sump wall. bonding of pipe to the entry fitting sive through the air passage. (A short section of 4"pipe may be and installing the threaded outlet 13.Connect only flexible tubing or used to drive the metal retaining fitting.Clean excess adhesive from hoses to the 1/4"side-outlet. ring over the fitting.)Be sure all bonding surfaces.See adhesive Note:Tubing or hoses must be there is an adhesive bead kit instructions for cure times. rated to full vacuum. i 1I1"hose barb adapter � TERMINATION EXAMPLE using / - SUMP ENTRY/TERMINATION FITTINGS Primary Pipe- . jj J _______—__ Red Thread IIA lA ¢ad insertion _ -- -- Concentric Reducer Make sure air passage is dear o 0 0 ( 0 0 The 1/4"threads are a"modified NPT"—the insertion of a Thread I Pipe- fted Thread IIA standard spec male thread is minimized. Sump Entry/Terminstion Fitting Smith Fibercast 7014 or 8014 adhesive is recommended. Spigot x NPT Adapter or Spigot x Spigot Nipple The 1/4"female threads are plastic and cannot be tightened Use concentric reducer to connect the sump entryttermination the same a metallic thread.Tighten to 40 in-lbs.or 1%a- 2 turns pastst hard tight. fining to secondary containment pipe;DO NOT USE Gam shell After installing a 1l4"NPT fitting,the passageway(s)to the termination fittings with this style fitting. piping interstitial space should be Geared with air pressure to insure that they are free of thread sealant and/or adhesive. It is the policy of Smith Fiberoest to improve its products continually. In accordance with that policy,the right is reserved to make charges in specifications,descriptions,and Illustrative material contained in this bulletin as conditions warrant. The Information con- tained herein is general in nature and is not intended to express any warranty of any type whatsoever,nor shall any be implied. Fiber GIaSS SyStww 1w STAR • SMITH • FIBERCAST 2700 West 65th Street 'JO 9001 PEI Little Rock, 672209 8-40 ar�ws. Telephone(501)1)566-4010 r Fax(501)568-4465 www.smithfibercastcom arlsrN fAsikNT PRINTED IN U.5 A 5M0705 ®2005 Nafional Oilwell VarO