Laserfiche WebLink
92555178,88 Lire 1 0 <br /> 11941 a.m. 12-01-2009 4/12 <br /> D. Results of Testing/Setvicing <br /> Software Version Installed: 120.02 <br /> Com lete the followin checklist: <br /> ® Yes ❑ No* Is the audible alarm operational? <br /> ® Yes ❑ No* Is the visual alarm operational? <br /> ® Yes ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> ® Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g., modem) <br /> ® N/A operational? <br /> ® Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary ja <br /> ent <br /> ❑ N/A monitoring system detects a leak,fails to operate, or is electrically disconnected? If yes: which senate <br /> positive shut-down? (Check all that apply) ®Sump/Trench Sensors; ®Dispenser Containment S <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ®Yes; ❑No. <br /> ❑ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning devino <br /> ® N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audiblenk <br /> fill point(s)and operating properly? If so,at what percent of tank capacity does the alarm trigger? <br /> ❑ Yes* (� No Was any monitoring equipment replaced? If yes, identify specific sensors,probes,or other equipmeed <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> ❑ Yes* ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all th❑Product; ❑Water. If yes,describe causes in Section E,below. <br /> ® Yes ❑ No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports, if applicabl <br /> ® Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? <br /> *In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Page 2 of 3 <br />