Laserfiche WebLink
• <br />• <br />Ll <br />FIBERGLASS PIPE GROUP <br />Fittings Dimensions in <br />2 through 6 -inch Sizes <br />for Dualoy 3000/L piping systems <br />Units <br />All dimensions are in U.S. Customary units (inches). <br />Adapters: bell x NPT male <br />Diametric dimensions are maximums. <br />Adapters: isolation <br />Insertion depths (X,, X2) are typical. <br />Adapters: spigot x NPT female <br />All weights (Ib) are approximate. <br />Tolerances <br />Tolerance for centerline -to -face dimensions on fittings with bell -end <br />45° Elbows <br />configuration is tyi6 inch. <br />Listings <br />Dualoy 3000/L is Listed in the U.S. with Underwriters Laboratories for nonmetallic <br />End caps <br />underground piping for petroleum products, alcohols (such as methanol and ethanol) <br />and alcohol -gasoline mixtures (File MH9162). Dualoy 3000/L pipe and fittings are <br />UUnderwriters Op <br />L Laboratories Inca U <br />also listed with Underwriters Laboratories of Canada for petroleum products and <br />fuels (File CMH 715), in the Netherlands with KIWA (Ref. ATA no. <br />`Y <br />oxygenated <br />2062/1-E), in Sweden with AB Statens Anlaggningsprovning (Certificate SA 1-1- <br />9846) and with the French Ministry of the Environment (ArrW 261 bis). In Great <br />Britain the Dualoy 3000/1- system has been tested and accepted by the London Fire <br />and Civil Defence Authority. <br />End configurations <br />Bell end is standard. <br />Taper angle <br />The taper angle on all bell and spigot end configurations is 13/4 . <br />Pressure ratings <br />See Ameron publication DUALLY 3000/L FIBERGLASS PIPE AND FITTINGS, FP265, for <br />pressure ratings. <br />Individual system components may not have the same ratings as the pipe. <br />Refer to the detailed product information for the specific components to <br />determine the pressure rating for the system as a whole. <br />Manufacturing methods <br />The fiberglass -reinforced epoxy resin fittings shown in this document are <br />manufactured by filament winding or compression molding. <br />Adapters: bell x NPT female <br />Flange rings <br />Adapters: bell x NPT male <br />Flange stub ends <br />Adapters: isolation <br />Nipples <br />Adapters: spigot x NPT female <br />Reducer bushings <br />Adapters: spigot x NPT male <br />Repair couplings <br />45° Elbows <br />Sleeve couplings <br />900 Elbows <br />Sump penetration pieces <br />End caps <br />Tees <br />FP266D (11/98) <br />