Laserfiche WebLink
Ub ld Yo 1o:U4 rue 12066LL9bza NW PUMP EQUIP. »»» TIME OIL _ X006 <br /> BRAVO <br /> IPW <br /> B-2000 DISPENSER l <br /> Ni-.,w INSIALLATIC NS <br /> A. To save on labor and time in removing debris, cover the <br /> 8-200 box with cardboard,plywood or heavy plastic during <br /> installation. C/L AMa° <br /> Myl\ <br /> B. Cover all threads to keep threaded connections clean. <br /> INTZNut\ <br /> 1. For each Bravo box, cut two 2 x 4's and secure to the island <br /> form.The angled supports are S" below the finished floor. (See O <br /> 3-A). The box flange should be even with the island's finished G/L <br /> floor. <br /> Aaplee CCUN ° <br /> 2. To determine the permanent position of the Bravo box inside G/ Sudodn: 3-A <br /> the island form: Use the angled comer supports on the Bravo <br /> Box to position, level and center the box in the island form, <br /> according to your specs. <br /> .3. Secure the box so it cannot shift during the concrete pour. <br /> Cement the anchor bolt to the island using the anchor bolt <br /> positions. <br /> 4. Properly protect the anchor nut threads during the island pour. <br /> IMPORTANT: To allow access to the plumbing and electrical a <br /> connections,DO NOT pour the slab or driveway. qConAeclo, 4.916 <br /> S. After concrete dries, remove backfill from one sideof the <br /> island, leaving access to the plumbing and electrical connec- netions.6. PRIMARY LINE: Connect a UL approved flex connector and nor <br /> coupling to the bottom of the product line,using a proper seal- 3•e <br /> ing compound. (Rigid fittings can be used for primary and sec- <br /> ondary line connections,if desired.)(See 3-B). <br /> 7. SECONDARY CONTAINMENT: Install flexible hose over the <br /> primary flex line and use recommended fasteners. Secure it to <br /> the B-18 fitting and to the primary or secondary pipe.(sel <br /> IMPORTANT: For rigid piping, apply a UL approved pipe <br /> sealant to the male threaded end.Hold the B-18 fitting stationary <br /> while securing the threaded pipe end to the bottom of the fitting. <br /> e Secondary containment piping can be terminated by 3"hose or <br /> by 3"rigid piping, a, o <br /> e The Bravo B-183 telescopic fitting (standard)has a 3" adapter seaooll second <br /> In „ <br /> eonoinmm Con4mmani <br /> for a 3"hose. ".11041 most 11"70 hNd <br /> •e Bravo's B-18.4 telescopic fitting can be used with a 3" rigid <br /> female NPT or a 4"hose(O.D.). 3-C <br /> continue to pose S <br /> 3 <br /> JUN-17-1998 16:06 12666229629 96% P.06 <br />