Laserfiche WebLink
Installer Menu T#70 Page 9/12 <br /> Scanner Not Used. Must be set to 0(Disabled). Scanner: 0 <br /> ----------------- <br /> Disabled 0 <br /> Enabled 1 <br /> Additive Enter the treat rate for the additive. For example, Product: <br /> (Treat Rate) 329 PPM x 8700 gallons of fuel=2.86 gallons of Tank 1 1 <br /> additive. <br /> Factor: <br /> 000329 (ppm) <br /> Select a Tank and confirm with"OK" <br /> or return with"Quit". • ' <br /> Enter the treat rate and confirm with"OK' <br /> or return with"Quit". <br /> ppm=Parts per Million <br /> `THE TREAT RATE MUST BE ENTERED <br /> FOR EACH TANK` <br /> Max.Dispense The maximum possible dispense.Default is 6 gallons. Free Mode <br /> Max.Dispense <br /> 000006.00 <br /> (4200.00) <br /> 5. General system reset <br /> This function will reset and erase the LMS Baby System (only firmware v3.9.) <br /> Note: All data have to be entered again! <br /> Procedure: <br /> Unplug the LMS Baby and press the buttons 1 and 2. <br /> Keep the buttons pressed and plug in the power supply. <br /> ! ! ! CAUTION ! ! ! ARE YOU SURE ? ARE YOU SURE ? <br /> This procedure <br /> will erase and Quit: Cancel Quit: Cancel <br /> reset the device. OK: Proceed OK: Proceed <br /> xxxx of 2126 <br /> LMS Baby System <br />