INSTALL_2013 - Laserfiche WebLink

Home Browse Search

CONTAINMENT Monitoring Fluid Fill Kit SOLUTIONS (KIT-MFFK) The Containment Solutions' Monitoring Fluid Fill Kit (Model MFFK)must be used when filling the monitoring space of a CSI double-wall tank sump. Follow allAlways wear safety glasses and protective clothing when Double-Wall Tank Sump Installation Instructions handling brine or propylene glycol solution. (Pub. No. INST 6034) prior to filling. Monitoring Fluid Fill Kit(Model Kit- MFFK)Contents: Fill the sump in the following order: • (1) 1'/" PVC threaded fill fitting with 2 short hoses 1. Prepare the required gallons of monitoring fluid for and barbed hose connectors. each tank sump. • (1)siphon gun. Gallons Monitoring Fluid Required • 1 8' Ion %u " ID Tank Sump ( ) long%u b y Y, plastic tubing. Total Height 42" 48" • (1)4' long%"OD by'/" ID plastic tubing. Round or Polygon Round or Polygon 4' 9 10 FIGUREA 5' 10 11 6' 11 13 + 7' 12 14 2. Press and hold the siphon gun trigger to begin fluid filling. 3. As the fluid level drops in the bucket, add fluid as needed to keep fluid level above the hose end. To siphon gun To monitoring fluid 4. When the monitoring fluid reaches the reservoir, (conned 4'tube) (connect 8'tube) release the siphon gun trigger. 5. When the vacuum is stopped, the fluid level in PVC Fill Fitting the reservoir will drop as the sump walls stabilize. Manually top off reservoir with monitoring fluid as indicated on sump label. 6. Wait until the fluid level in the sump stops changing (24 hours is recommended)and then top off the reservoir. The desired final monitoring fluid Perform the preparation in the following order: level is indicated on the side of the reservoir. 1. Remove the permanent 1'/2" reservoir plug from 7. Remove the PVC fill fitting, insert the single point sump reservoir and set aside for later use. float sensor and re-install the 1'/2' permanent 2. Install and hand tighten the 1'/2" PVC fill fitting into reservoir plug. Be sure the reservoir plug has at the sump reservoir coupling. No thread dope or least a''/"diameter hole in the top of the plug or Teflon tape is required (see Figure A). around the wire for venting of the reservoir. Do not 3. Connect the 8' plastic tubing to the monitoring caulk or otherwise seal the vent space between the wire and the fitting hole. fluid tubing barb and place the opposite end of the tubing in a bucket of monitoring fluid.Temporarily attach the tubing to the bucket to keep the end positioned at the bottom of the bucket. 4. Connect the 4' plastic tubing to the siphon tubing barb and connect the opposite end to the siphon connection on the siphon gun. Field Service Dept. Technical Support 5. Connect the siphon gun to an air compressor. Mt. Union, Pennsylvania Conroe,Texas Regulate the supplied air pressure to not exceed (800)822-1997 (800)5374730 100 psi.Typical air consumption is 13.7 scfm at (814)542-6520 (936)756-7731 100 psi. copyright®2009 Containment Solutions,Inc.•All RII Reserved•October 2009•Pub.No.INST 6049 1