Laserfiche WebLink
,,Dec 15 09 09: 51a Elit6V Contactors 120946342 p. 9 <br /> Installation Instructions Expansion Board Installation <br /> Q) 1. <br /> Tum off power to the console. <br /> 2. If wiring to existing interface modules blocks access to the large six-slot cover plate,you should <br /> unplug the connectors from the modules,but not the modules from their slots. <br /> Before removing any connectors,tape and label them and the modules to which they attach so you <br /> can reconnect them correctly. <br /> 3. Remove the six-slot cover from the bay in which you are installing the Expansion Board by <br /> pulling out on the snap-in fasteners in each comer and then lifting the cover out of the console. <br /> 4. Align the Expansion board connector with the connector on the motherboard or I.S.Barrier board <br /> (see Figure 1). <br /> 5. Push the Expansion Board down to engage the connectors. <br /> 6. Align the two(2)holes in the Expansion Board with the two PEM nuts shown in Figure land <br /> screw in the two retaining screws(on consoles with snap pins,press in carefully on the board until <br /> the pins snap in the holes). <br /> 7. Cover all unused slots with the single-slot snap-in covers furnished with this kit.ALL UNUSED <br /> SLOTS MUST BE COVERED! <br /> 8. Press down firmly on the cover's two snap-in fasteners to secure each slot cover in place. <br /> 4 <br />