Laserfiche WebLink
Dec 17 09 03: 58p Elite Contactors 12094642 p. l <br /> TLS-350 Series Sensor Module Installation Guide Connecting Sensor Wiring to Modules <br /> O 3. Locate the IS bay in the right side of the console (Figure 2).Avoid shorting high voltage across any <br /> component or module to the intrinsically safe (IS) bay of the console.This could result in an explosion near the <br /> sensor. <br /> !� <br /> --- <br /> Intrinsically _-- <br /> .,5 Safe Bay <br /> t-= ---t =-=- Permissible —t <br /> F Do not install : �4 Modules <br /> its Qsensor modules (Limit 8 <br /> { In this bay! <br /> g=_ - .,3 per console) <br /> v <br /> IN 121 <br /> , <br /> C1 i <br /> Figura 2. Locating the intrinsically safe bay in the TLS Console <br /> 4. Remove the blank panel from the desired module slot in the IS bay. <br /> 5. Carefully slide the new module into the slot until the connector on the rear of the module engages completely <br /> with the connector on the expansion board at the back of the slot.Do not apply excessive force. <br /> 6. Press in the snap-in fasteners on each side of the module's face plate to"lock"the module in place. <br /> Z When finished installing modules, make sure all unused slots in the console are covered with snap-in blank <br /> plates! (Veeder-Root Module Cover Part No.329339.001.) <br /> QIMPORTANT!If you are installing these modules in a system that has already been programmed,you cannot <br /> change the position of existing modules and/or connectors without reprogramming the entire system. If any <br /> connectors were removed during installation,be sure they are reconnected to their original modules. Improper <br /> system operation will result if any sensor/module position is changed without re-programming. <br /> Connecting Sensor Wiring to Modules <br /> Connectors are supplied with each interface module.They provide screw terminations for sensors.See Table 1 on <br /> page 6 for interface module type and its maximum allowed number of sensors.Be sure to record on the circuit <br /> directory the type of module and the name or location of each sensor wired to each connector. <br /> 5 <br />