Laserfiche WebLink
i' <br />D. INSTALZA ON: (CoNTINUED) Page 13 of 13 <br />2. WIRING METHODS: Splice branch circuit conductors #10AWG or smaller, as follows: <br />Twist conductors together, solder and tape with rubber and friction to <br />or <br />high -dielectric strength plastic tape, or use reinsulated r �� type <br />connectors, Scotchlok, Ideal, W P spring -pressure type <br />Wing -Nut, or equal. <br />Branch circuit conductors shall be color -coded to match existing. <br />Conduit systeMS, supports, cabinets, motor frames, etc., shall be permanently <br />and effectively grimed per Code. <br />Information on plans relative to existing installation is approximate only. <br />Minor deviations found necessary during progress of work to conform to actual <br />locations shall be made as required. <br />3. . Provide nameplates on all switches and revise panel -board directory <br />to suit new work. <br />H. GROUNDING: Grounding of all equipment shall be per local requirements. Ground and <br />bond all cabinets, conduits, electric appliances, equipment, motor frames and motor <br />bases in accordance with requirements of the National Eelctrical Code. Grounding <br />connection shall be accessible for inspection and shall be made with an approved <br />ground clamp. <br />I. MECTMNICAL DQUIPME ur: Provide starters and disconnect switches where indicated. See <br />manufacturer's drawings. <br />J. HAZARDOUS AREAS: Conduit system fittings and electrical equipment shall conform to <br />NEC Section 500, Class 1, Group D, Hazardous Classification. <br />6-152 DISPENSER TESTS <br />A. Dispenser meters shall be adjusted as near as possible to zero error. Advise Owner's <br />representative of any meter that cannot be held to + or - 3-1/2 cubic inches of <br />tolerance in a 5 -gallon measure for repair under manufacturer's warranty if <br />applicable. Tests will be made according to methods prescribed by department of <br />weights and measures. Cost of pump operating license shall be paid by Owner. <br />5-153 AS BUI1Z EPAWINGS <br />k. The Contractor shall be required to work up a drawing or a print sizing and locating <br />all underground lines. This drawing must be submitted to the Owner upon ccmpletion <br />of job. <br />6.24 <br />