Laserfiche WebLink
RECFiV' ED <br /> Once the cam-lock is secure refit the water <br /> -- ENVIRONMENTAL HEALTIgHroud platform. <br /> OERAR.TMENT <br /> Note: It may be necessary to further adjust <br /> optimal until the height the cam-lock o position <br /> 9 P <br /> is located. <br /> 4 � <br /> \ "Icp\`�------__-�=. <br /> Figure 38 <br /> 61. Install water shroud platform and boots over <br /> spill containers. See Figure 39. <br /> T y-i Figure 40 <br /> f 3--.- <br /> 1 t w <br /> T-HAN a LE <br /> Figure 39 <br /> 62. Seat the water shroud platform on the <br /> stainless steel ring. Press down on the _ WATERTIGHT LID <br /> water shroud platform. Turn the T-handles - <br /> 90 degrees to lock the latch beneath the <br /> stainless steel ring. See Figure 40. <br /> If the T-handle(See Figure 41)fails to <br /> engage it may be necessary to adjust the <br /> cam-lock' height. <br /> I <br /> If the T-handle is not fully engaging it means �! FCtING NLri' <br /> the cam-lock needs to be lowered. Loosen <br /> the base nut(see Figure 42)to a lower `�1 LARGE LOCKENG WASHER <br /> position. Pull the cam-lock down to rest <br /> onto the base nut(see Figure 43). Lower 1 <br /> and tighten the fixing nut until the cam-lock CAM-LOCK <br /> is secure as shown in figure 45. _ <br /> If the lid is not compressing the gasket I <br /> tightly against the stainless steel ring it <br /> means the cam-lock needs to be raised. j LARGE LOCKENG WASHER <br /> Loosen the base nut(see Figure 42) and <br /> pull the cam-lock down to rest onto the base j BASE N�JT <br /> nut and raise the fixing nut(see Figure 44). �� <br /> Push the cam-lock up to the fixing nut and <br /> tighten the base nut until the cam-lock is Figure 41 <br /> secure as shown in figure 45. <br /> 106 210271 — Fibrelite Multiport Spill Container <br />