Laserfiche WebLink
Anheuser-Busch/Arch Road <br /> Site Safety Plan <br /> February 11, 1992 <br /> 9.6 Drilling Procedures <br /> A Dig-Alert authorisation number must be obtained prior to drilling. <br /> During the drilling operation, two persons (one designated as "driller" <br /> and the other as "helper") must be present at all times. The helper <br /> (whether Groundwater Technology, Inc. personnel or subcontractors) must <br /> be instructed as to the location of the emergency shut-off switch. <br /> Every attempt must be made to keep unauthorized personnel from entering <br /> the work area. If this is not possible, the operation should be shut <br /> down until the area is cleared. The area where the operation is taking <br /> place shall be cordoned off with a barricade. The Site Safety Officer <br /> or the Field Team Leader has the authority and the responsibility to <br /> shut down the drilling operations whenever a hazardous situation is <br /> deemed present. <br /> The mast of the drilling rig must maintain a minimum clearance of 20 <br /> feet from any overhead electrical cables. All drilling operations will <br /> cease immediately during hazardous weather conditions such as high <br /> winds, heavy rain, lightening and snow. <br /> Hart hats shall be worn at all times. Hearing protection shall be worn <br /> during noisy operations. <br /> If product is encountered during the drilling operation, all work must <br /> stop in order for employees to upgrade personal protective equipment to <br /> Level C. A full-face respirator should be worn in order to prevent the <br /> inhalation of vapors and to provide face and eye protection from <br /> splashes. Coated tyvek suits, gloves, and overboots should be worn to <br /> prevent skin contact with the soil. <br /> Air monitoring must be performed in the work area to document <br /> breathing-zone concentrations. If air monitoring results indicate <br /> concentrations greater than 750 ppm, then Level B respiratory <br /> protection will be implemented. <br /> Respirator cartridges must be changed at the end of a work period or if <br /> "breakthrough" occurs. If employees experience continuous cartridge <br /> "breakthrough", then the employees' work procedures and the level of <br /> respiratory protection must be re-evaluated by the Site Safety Officer <br /> and the Health and Safety Manager in order to determine the necessity <br /> of upgrading to Level B respiratory protection. <br /> 9.7 Electrical Ecuioment and around-Fault Circuit Interrupters <br /> All electrical equipment and power cables in and around wells or <br /> structures suspected of containing chemical contamination must be <br /> intrinsically safe and equipped with a three-wire ground lead, rated <br /> explosion-proof for hazardous atmospheres. In accordance with OSHA 29 <br /> CFR 1926.404, approved ground fault circuit interrupters (GFCI) must be <br /> used for all 120 volt, single phase, 15 and 20 ampere receptacle <br /> 20 <br />