CO0045285 - Laserfiche WebLink

Home Browse Search

Personal precautions: Put on appropriate personal protective equipment(see Section 8.). Environmental precautions Clean-up methods-large spillage.Remove all sources of ignition.Absorb spill with inert material(e.g. and clean-up methods: dry sand or earth),then place iiinnia chemical waste container.Use a water rinse for final clean-up. Handling: Avoid contact with skin,eyes and clothing.Do not taste or swallow.Avoid breathing vapors or mists.Use only with adequate ventilation. Remove and wash contaminated clothing and footwear before re-use.Wash thoroughly after handling.Product residue may remain on/in empty containers.All precautions for handling the product must be used in handling the empty container and residue.COMBUSTIBLE LIQUID AND VAPOR.Keep away from open flames,hot surfaces and sources of ignition.Use only In well-ventilated areas.Mix only with water.Do not mix with any other product or chemical. FOR COMMERCIAL AND INDUSTRIAL USE ONLY. Storage: Protect from freezing.Keep tightly closed in a dry,cool and well-ventilated place.KEEP OUT OF REACH OF CHILDREN. Aerosol Level(if applicable): Not applicable Exposure Guidelines: In redlent s CAS# ACGIH OSHA Didecyl dimethyl ammonium chloride 7173-51-5 n-alk I dimethyl benzyl ammonium chloride 68424-85-1 Ethyl alcohol 64-17-5 1000 ppm(STEL) 1000 ppm(TWA) 1900 mg/m3 A Tetrasodium salt of EDTA 64-02-8 Lauryl dimethyl amine oxide 1643-20-5 Sodium sesquicarbonate 533-96-0 - - Undiluted Product: Engineering measures to reduce exposure: Good general ventilation should be sufficient to control airborne levels Respiratory protection is not required if good ventilation is maintained. Personal Protective Equipment Eye protection: Chemical-splash goggles. % Hand protection: Chemical-resistant gloves. l Skin and body protection: Protective footwear.If major exposure is possible,wear suitable protective clothing and footwear. Respiratory protection: In case of insufficient ventilation wear suitable respiratory equipment.A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements must be followed whenever workplace conditions warrant a respirator's use. Hygiene measures: Handle in accordance with good industrial hygiene and safety practice. Diluted Product: ,y�r Personal- ..4.ive Equipment., epro ectro Noaaf`req irgmegfs uq o a is h �' tr "4 ; hf a Hand protection Nos ectal reg0irements dnde�a sero d�tials , , 3��Skin an ori.-:Protection. ry Nd ecial5,equi`'"iemenfs I nrrdeCnnormma eta diU nos v y„ `;{,,f k :., ' �- Res ire ory:p o ectron;' ,o-5pec�al requlre..m,_enls un�ynormal use conditions: n ygiene measu es: 'anle id"accq dance with good mdustnat bygie eandsa e'typracUce - Physical State: Liquid Color: Clear, Blue Evaporation Rate: No information available Odor: Minty Odor threshold: No information available. Boiling pointirange: Not determined Melting pointlrange: Not determined Decomposition temperature: Not determined Autoignition temperature: No information available Solubility: Completely Soluble Solubility in other solvents: No information available Relative Density(relative to water): 1.0 Density: 8.34 lbs/gal 1 Kg/L Vapor density: No information available Bulk density: No information available Vapor pressure: No information available. Flashpoint: „ 187 'F 86.1 °C Partition coefficient(nroctanollwater): No information available 1 &-, iscosity:No information available Elemental Phosphorus: 0.00 %bywt. VOC: 3.58 %' PH: 10.2 VOC%by wt.at use dilution 0.01 %' Flammabllity(Solid or Gas): Not applicable Metal Corrosion: Not determined Virex 11256 One-Step Disinfectant Clenaer and Deodorant;Quat Based Disinfectant 3 of 6