COMPLIANCE INFO 2016 - 2017 - Laserfiche WebLink

Home Browse Search

AUG 15201, Bravo CONY Retrofit Plan 8/21/12 Plan for control of the CONV Retrofit Plate ENVIRONMENTAL HEALIVH r,-_DnPT- APNT The Conversion Frame Retrofit Plate Kit is required only in very specific situations where existing electrical conduits are locked in concrete just outside the UDC opening. In this case, in order for the UDSCCS to be installed and function properly, holes must be cut or drilled in the conversion frame to accommodate the existing conduit lines and possibly the E-Y adapters. Bravo ensures absolute environmental protection by providing a fiberglass plate kit that is permanently bonded onto the conversion frame panels to cover the holes/cuts and to also seal directly to the conduit lines using fiberglass epoxy. The installation of this Retrofit Plate kit maintains the design and function of the drainage panels by containing any leaks from within the hydraulic cabinet —especially any fluids that may run down or along conduit lines- and channeling them into the interior of the UDC below. Bravo process for policing the CONV Retrofit Plate installation for existing external conduits. A) Bravo is contacted directly by the installer, or Bravo contacts the installer to communicate directly. By email, or by phone followed by email. Bravo does not communicate procedure or installation directions verbally. Bravo will maintain a paper trail history of each installation it authorizes. B) A completed Conversion Frame Evaluation Form will be sent to Bravo to help with evaluation and for records. C) For evaluation, the installer or an agent must send to Bravo complete, clear & unobstructed images of the conduit areas in relation to the existing UDC's. Bravo asks for closeup images and also images with the entire dispenser within the cameras frame. D) The installer is verified to be Bravo-Certified before authorization & installation. E) The installer must use only Bravo-supplied CONV Retrofit Plate components and materials for the Bravo Conversion Frame tailored to the specific installation on a per address/application basis after site evaluation. F) The installer may only install the CONV-132000 Conversion Frame along with the CONV Retrofit Plate kit when authorized in writing by Bravo letterhead on a per installer, per address and per application basis. In some cases the directions may need to be modified slightly to better apply to the specific layout of the conduit area. G) The installer must follow only our written instructions for this specific installation procedure. H) Post-installation the installer must send to Bravo images of the completed installation for review and further action as required. To be determined by Bravo engineering staff. Images are to match the pre-installation images as closely as possible to provide a before & after set.