Laserfiche WebLink
02/22:'99 17:c4 <br /> NO.03 X17 <br /> Bonding primary Using heating blankets <br /> systems (cont.) Ameton heating blankets provide an efficient means for curing adhesive-bonded joints. <br /> fter, Two sizes are neadad for installing --- - <br /> l�u � faualoy 3000/L systems.Refer to Chem Cure Pak quantities and heating <br /> following table when ordering. blanket sizes <br /> The heating blanket reaches a Nominal Chem Heating <br /> pipe Size Cure Pak Blanket <br /> maximum temperature of"'F (in (rnm} Units per Carton. .. Size <br /> (150°C),which will cure Ameron B23 n �._._.._ <br /> L bre �l r3 I <br /> adhesive in approximately 30 to 40 3 so 30 I <br /> minutes.Detailed instructions are 4 100 20 I <br /> included with the blanket Observe the �' 150 20 11 <br /> following points: ----T W-- --__I <br /> • Use one heating blanket per bond:sleeve couplings In 3-inch sizes and larger <br /> will require two blankets.However,a single blanket is sufficient for Curing both <br /> bonds in a 2-inch sleeve coupling. <br /> • Tia the blanket in place with nonconducting ties, <br /> • Before connecting to a power source,inspe4-t the blanket and cord for loose wire <br /> connections and bare wires. <br /> • Do not plug the cord into a power source when standing in water or on a wet <br /> surface. <br /> • Check;that the heating blanket has the correct AC voltage rating for your locality. <br /> Do not use direct current. <br /> • Mark the starting and disconnect time on the Alpe with a grease pencil so that <br />